Mountain pine beetle (Dendroctonus ponderosae Hopkins; Coleoptera: Curculionidae) is a major disturbance agent in pine (Pinus Linnaeus; Pinaceae) ecosystems of western North America. Adaptation to local climates has resulted in primarily univoltine generation time across a thermally diverse latitudinal gradient. We hypothesised that voltinism patterns have been shaped by selection for slower developmental rates in southern populations inhabiting warmer climates. To investigate traits responsible for latitudinal differences we measured lifestage-specific development of southern mountain pine beetle eggs, larvae, and pupae across a range of temperatures. Developmental rate curves were fit using maximum posterior likelihood estimation with a Bayesian prior to improve fit stability. When compared to previously published data for a northern population, optimal development of southern individuals occurred at higher temperatures, with higher development thresholds, as compared with northern individuals. Observed developmental rates of the southern and northern populations were similar across studied lifestages at 20 °C, and southern lifestages were generally faster at temperature extremes (10 °C, 27 °C). At 25 °C southern fourth instars were significantly slower than northern fourth instars. Our results suggest that evolved traits in the fourth instar and remaining unstudied lifestage, teneral (i.e., preemergent) adult, likely influence latitudinal differences in mountain pine beetle generation time.

Wheat stem sawfly, Cephus cinctus Norton (Hymenoptera: Cephidae), indigenous to North America, quickly adapted from host native grasses to wheat crops (Triticum Linnaeus (Poaceae)) with expansion of agriculture on the Great Plains of North America. Bioclimatic simulation tools, such as Climex, predict the potential geographic distribution and establishment of insects in ecosystems, based on climate. The ecoclimatic index, a measure of ecological suitability, integrates potential population growth with stresses to produce estimates of relative abundance. This simulation software was used to develop a bioclimate model for C. cinctus in western Canada. Results fostered a better understanding of how C. cinctus responded to selected climate variables. Two general circulation models were then applied to assess the response of C. cinctus populations to future climate. Relative to current climate, predicted changes in C. cinctus distribution and relative abundance were greatest for 2030, with a small further increase for 2070. Across the Prairies and Boreal Plains Ecozones, changes in ecoclimatic index were greater than in geographic distribution. Both general circulation models indicated most of this area would be categorised as very favourable. This suggests that the potential for pest populations could expand into areas that do not currently experience economic losses associated with C. cinctus.

Drosophila suzukii (Matsumura) (Diptera: Drosophilidae), was first detected in 2009 in the Okanagan Basin, British Columbia, Canada. During 2010–2016, 94 570 fruits of 35 non-crop species, from 12 plant families, were collected from 101 sites where adult D. suzukii flies were trapped, and incubated in a controlled environment. In total, 450 adult D. suzukii emerged from 62 of 929 fruit collections, and from 10 host plant species in five families, of which six species are native to the region. Five plant species are reported for the first time as hosts of D. suzukii, and 11 species for the first time as non-hosts. Measures of fly occurrence and infestation reveal it to be relatively abundant in five hosts and low in others. The fly reproduced in a succession of host plants, with first infestation of each from mid-July through mid-September, and was present until mid-October, but overwintering stages were not found. Degree-day accumulations for the infested period suggest that three to five generations of D. suzukii developed on non-crop plants and formed a large contribution to the annual increases observed in trap counts in a semi-arid cold winter climate, with implications for many strategies of pest management.

Monarch butterflies (Danaus plexippus (Linnaeus) (Lepidoptera: Nymphalidae)) in eastern North America migrate each year from overwintering areas in Mexico to cover a large breeding distribution across the United States of America and southern Canada. In 2012, monarch butterflies migrated well beyond their usual range, resulting in an extended breeding distribution compared to typical years. We used stable isotope (δ2H, δ13C) measurements in wing chitin to determine the area of natal origin of these butterflies. Most monarch butterflies collected in May, June, and July from Manitoba and Alberta, Canada had natal origins in the North American Midwest. Monarch butterflies collected in Alberta and Saskatchewan, Canada in August and September had local natal origins indicating successful recruitment of offspring from colonising individuals. However, it is unknown whether these offspring migrated successfully to overwintering areas. Our work highlights the ability of monarch butterflies to colonise distant breeding areas and demonstrates how stable isotopes can be used to understand the dynamics of range-edge populations.

Many studies have investigated plant-pollinator interactions using visit records of insects contacting floral reproductive organs. However, these studies may not reflect the effectiveness of visits, since factors such as visitor behaviour and the composition of pollen on their bodies may influence conspecific pollen transfer required for fertilisation in plants. Here we study how pollen transport to a generalist wildflower, Camassia quamash (Pursh) Greene (Asparagaceae), is influenced by the behaviour and body pollen of five functional visitor groups (Andrena Fabricius (Hymenoptera: Andrenidae)/Halictidae (Hymenoptera), Apis mellifera Linnaeus (Hymenoptera: Apidae), Bombus Latreille (Hymenoptera: Apidae), Osmia Panzer (Hymenoptera: Megachilidae), and Syrphidae (Diptera). We found that functional visitor groups differed in their behaviour (Bombus and Osmia were legitimate visitors, contacting both anthers and stigmas) and in the amount of conspecific pollen on their bodies (A. mellifera had the highest levels and Andrena/Halictidae the lowest). Conspecific pollen receipt by C. quamash stigmas was high (>80%), and best explained by visitor behaviour rather than the proportion of visitors with high amounts of conspecific body pollen. Our findings highlight the utility of pollen analyses for understanding pollinator effectiveness.

Life history traits, such as clutch size, egg size (weight), developmental periods of eggs, and female body (abdomen) size, were investigated in Japanese species of the genus Elasmostethus Fieber (Hemiptera: Acanthosomatidae): E. amabilis Yamamoto, E. brevis Lindberg, E. humeralis Jakovlev, E. interstinctus (Linnaeus), E. kerzhneri Yamamoto, and E. nubilus (Dallas). With the exception of clutch size, significant differences were observed in the traits among species. No species exhibited maternal care of eggs. These data form a solid basis for future comparative analyses in the family Acanthosomatidae, which contains both subsocial and asocial species.

The pine bark adelgid, Pineus strobi (Hartig) (Hemiptera: Adelgidae), is an herbivore native to eastern North America that specialises on eastern white pine, Pinus strobus Linnaeus (Pinaceae). Little is known about P. strobi, especially in its southern range in the Appalachian Mountains, United States of America, and the composition of its predator complex has not yet been documented in this region. The current study identifies arthropod predators associated with P. strobi in Appalachian forests of Virginia based on a two-year survey. Predators were identified using morphology and DNA barcoding. Predator species include: Laricobius rubidus LeConte (Coleoptera: Derodontidae), Leucopis piniperda Malloch (Diptera: Chamaemyiidae), and Leucopis argenticollis Zetterstedt (Diptera: Chamaemyiidae), that are known adelgid specialists. Also found were predators from the families Cecidomyiidae (Diptera), Coccinellidae (Coleoptera), Chrysopidae (Neuroptera), Hemerobiidae (Neuroptera), and Syrphidae (Diptera). The Cecidomyiidae were especially diverse, with 14 different species inferred from their DNA barcodes. Knowledge of this predator complex is particularly valuable for anticipation and detection of potential interactions between native predator species and those that are being considered for the introduction for biological control of invasive adelgid pests within the southern Appalachian ecosystem.

Cabbage seedpod weevil (Ceutorhynchus obstrictus Marsham; Coleoptera: Curculionidae) and Lygus Hahn (Hemiptera: Miridae) species are part of the late season insect pest complex of canola (Brassica Linnaeus; Brassicacea) in the southern prairies of Canada. From 2010 to 2013, large strips in 73 commercial fields were studied in southern Alberta to validate action thresholds for cabbage seedpod weevil and assess the impact of insecticide spraying at the early flower stage for cabbage seedpod weevils on abundance of Lygus at the pod stage. Only fields planted in April accumulated the damaging populations of cabbage seedpod weevils, such that the application of an insecticide resulted in significant yield protection. The economic injury level for the cabbage seedpod weevil was calculated at 20 cabbage seedpod weevils per 10 sweeps, but an action threshold of 25–40 is recommended because sampling mainly occurs along the edge where cabbage seedpod weevils are initially concentrated. At the pod stage, Lygus were lower in strips sprayed with insecticides at the early flower stage than in those not sprayed, but the differences were not statistically significant. Furthermore, Lygus were generally below economically damaging levels in early seeded fields. Therefore, there is no benefit of spraying early seeded fields to attempt to prevent Lygus outbreaks when cabbage seedpod weevils are below thresholds because Lygus may pose a risk only in fields planted later in the season.

The insecticide chlorantraniliprole is recommended for integrated pest management programmes of caterpillar (Lepidoptera) pest species. This insecticide is considered harmless to parasitoids, but its selectivity may vary with the species of natural enemy, few of which were subjected to testing. Furthermore, in addition to the active ingredient, formulation adjuvants may improve insecticide efficiency, but also its impact on nontargeted organisms. Here the chlorantraniliprole effect and its interaction with adjuvant on the survival and qualitative parameters of progeny of the nontarget parasitoid Palmistichus elaeisis (Delvare and LaSalle) (Hymenoptera: Eulophidae) were studied. The treatments used were: chrolantraniliprole (T1), chlorantraniliprole+surfactant (T2), and deionised water (T3, control). Pupae of Diaphania hyalinata Linnaeus (Lepidoptera: Crambidae) were subjected to these treatments for 24 hours and offered to the adult parasitoids. Chlorantraniliprole and chlorantraniliprole+surfactant did not elicit direct toxicity to female parasitoids. However, chlorantraniliprole and its combination with surfactant reduced the head capsule width of the female progeny. This insecticide alone also reduced emergence and the progeny metatibia length. Chlorantraniliprole did not induce mortality of P. elaeisis adults, but its negative impact on the emergence and progeny size of this parasitoid suggests an important sublethal effect to be considered.

Adelges tsugae Annand (Hemiptera: Adelgidae) has caused extensive mortality of hemlocks (Tsuga (Endlicher) Carrière; Pinaceae) in the eastern United States of America and was discovered recently in Nova Scotia, Canada. We evaluated the use of a Velcro-covered racquetball as a sampling device for A. tsugae wool. Specifically, we report on improvements to an earlier design and evaluate several factors seen in routine sampling that influence the ability of the ball to trap and retain adelgid wool. Velcro was found to be critical for trapping and retaining adelgid wool on the ball during flight and landing. Wooden beads, inserted in the ball, reduced deflection during flight and bounce during landing. Higher probability of trapping wool on the ball was associated with an ascent through the crown, with increasing diameter and density of ovisacs on branch tips, and with increasing abundance of woolly twigs on the forest floor. Higher probability of retaining wool on the ball was associated with Velcro surface area and with amount and location of wool loaded on the ball. These modifications improved detection surveys for A. tsugae in general.

An insect trap constructed using three-dimensional (3D) printing technology was tested in potato (Solanum tuberosum Linnaeus; Solanaceae) fields to determine whether it could substitute for the standard yellow sticky card used to monitor Bactericera cockerelli (Šulc) (Hemiptera: Psylloidea: Triozidae). Sticky cards have shortcomings that prompted search for a replacement: cards are messy, require weekly replacement, are expensive to purchase, and accumulate large numbers of nontarget insects. Bactericera cockerelli on sticky cards also deteriorate enough that specimens cannot be tested reliably for the presence of vectored plant pathogens. A prototype trap constructed using 3D printing technology for monitoring Diaphorina citri Kuwayama (Hemiptera: Psylloidea: Liviidae) was tested for monitoring B. cockerelli. The trap was designed to attract B. cockerelli visually to the trap and then funnel specimens into preservative-filled vials at the trap bottom. Prototype traps were paired against yellow sticky cards at multiple fields to compare the captures of B. cockerelli between cards and traps. The prototype trap was competitive with sticky cards early in the growing season when B. cockerelli numbers were low. We estimated that two or three prototype traps would collect as many B. cockerelli as one sticky card under these conditions. Efficacy of the prototype declined as B. cockerelli numbers increased seasonally. The prototype trap accumulated nontarget taxa that are common on sticky cards (especially Thysanoptera and Diptera), and was also found to capture taxa of possible interest in integrated pest management research, including predatory insects, parasitic Hymenoptera, and winged Aphididae (Hemiptera), suggesting that the traps could be useful outside of the purpose targeted here. We believe that 3D printing technology has substantial promise for developing monitoring tools that exploit behavioural traits of the targeted insect. Ongoing work includes the use of this technology to modify the prototype, with a focus on making it more effective at capturing psyllids and less susceptible to capture of nontarget species.