Sar

Dual-frequency, polarimetric airborne SAR has been named Pi-SAR (polarimetry in the X- and L-band, and interferometry in the X-band). It was developed by the Communications Research Laboratory (CRL/X-band) and the National Space Development Agency of Japan (NASDA/L-band). In the Pi-SAR, the frequencies for the X- and L-bands are 9.55 GHz (3.14 cm wavelength) and 1.27 GHz (23.5 cm wavelength). The spatial resolutions are 1.5 m for the X-, and 3.0 m for the L-band. The radar systems are mounted on an aircraft (Gulfstream II), and the image data are taken at a flight speed of about 200 m f_l at altitudes of 6000−12 000 m. The two frequency systems operate simultaneously. The ground-range swath is approximately 15 km, and typical incidence angles are 20−60° (Reference Kobayashi, Satake, Manabe, Masuko and ShimadaKobayashi and others, 1998). The radiometric calibration is better than ±1.5 dB in backscattering coefficient. In this paper, we focus on the backscattering magnitude data. The phase calibration is still ongoing; polarimetric analysis including the phase dependence of backscattering from sea ice is not discussed.

Test site

The Pi-SAR observations of sea ice in the Sea of Okhotsk were carried out near the northeastern coast of Hokkaido, Japan. The data were acquired on 23 and 24 February 1999, in conjunction with RADARSAT SAR observations (C-band; 5.3 GHz, HH polarization, spatial resolution about 30 m). In situ truth data of the floating sea ice were not obtained because it is difficult to access the thin, unstable sea ice. However, photographs of the sea ice from the aircraft were taken simultaneously during the Pi-SAR observations when weather permitted.

Figure 1 shows a map of the test site and the RADARSAT SAR image acquired on 23 February 1999. The SAR image covers about 53 km × 53 km. The radar incidence angle to the area is between 23° for the left side and 25° for the right side. More than 90% of the sea in the image was covered with sea ice at the time of the observation. The large sea-water lake (with salinity of > 30ppt (parts per thousand)) covered with sea ice near the coast in the lower center of the image is Lake Saroma. The white rectangle represents the Pi-SAR observation area, shown in Figure 2.

Fig. 1. Map of test site and radarsat sar (c-hh, incidence angle of 23−25°) image acquired on 23 february 1999.

Fig. 2. Pi-sar images of (a) x-band, and (b) l-band acquired on 23 february 1999, as color composites of hh (red), vv (green) and hv (blue) channels. swath width is 13.5km and azimuth distance is 50.0 km.

Figure 2a and b show the Pi-SAR browse images of the X- and L-bands, acquired on 23 February 1999, as color composites of the HH (red), VV (green) and HV (blue) channels. The swath width is 13.5 km and the incidence angle is between 20° (near range) and 57° (far range). Lake Saroma is on the right in the image. These browse images were processed for the large area with low resolution (10 m); some nominal radiometric contribution has not been removed in the processing of range direction. In the following section, we used well-calibrated detailed images to describe the backscattering properties of sea ice.

Frequency dependence

We show the frequency dependence of SAR backscattering using the Pi-SAR and RADARSAT data with specific incidence angle (24° ± 1°) and polarization (HH). Figure 3a and b show detailed images of square 1 in Figure 2. Figure 3a corresponds to the image in Figure 2a, and Figure 3b to that in Figure 2b. The image covers 3 km × 3 km, and the incidence angle is 23−34°. Figure 3c shows a RADARSAT image (standard mode; SI) of the same region. From the photographs of the sea ice taken from the aircraft, and from our knowledge of the dielectric properties and typical surface conditions of sea ice, we reach the following empirical conclusions about the area types. There are four basic types. The first is open water (OW) shown by dark areas (weak backscattering) in all three frequency images. When the water was calm, the backscattering coefficients almost reached the noise level due to the specular reflection of the microwaves. The second type is thin ice (TI), such as nilas and gray ice, shown by dark areas similar to the area of open water in the low-frequency image, but distinguishable in the high-frequency (X-band) image. The third type is smooth surface first-year ice (S-FYI) shown as a bright area in the high-frequency image, and as a slightly bright, rounded area surrounded by bright curved lines in the low-frequency (L-band) image. The last type is rough surface first-year ice (R-FYI) visible as bright areas in all three images.

Fig. 3. Extended Pi-SAR images of square 1 in Figure 2 in (a) L-band HH, and (b) X-band HH. Incidence angles of the marked areas are 23-25°. (c) RADARSAT images of the same area. Each image is 3 km × 3 km.

The backscattering coefficients of these surfaces using frequency as a parameter, at incidence angles of 23−25°, are shown in Table 1. The backscattering coefficients are the mean values of the marked areas in Figure 3a–c. The incidence angles of the marked area were 23−25° in Figure 3a and b; the incidence-angle dependence on the backscattering coefficient was negligible. There is a difference of approximately 10 dB between the open water and the thin ice in the X-band, and of approximately 3 dB in the L- and G-bands. The X-band is very effective in detecting thin-ice zones, whereas the L-band discriminates well between smooth and rough surface first-year ice.

Table 1. Frequency dependence of backscattering coefficients (db) from sea and various sea-ice surfaces at incidence angles of 23−25°. mean values of each marked square in figure 3a–c are shown

Polarization characteristics of thin ice

Figure 4a shows an image of the Pi-SAR X-band, and Figure 4b an image of the L-band, as color composites of the HH (red), VV (green) and HV (blue) channels. The images are detailed ones of square 2 in Figure 2, and represent an area of 5 km × 5 km. There was a large difference between the backscattering coefficients in the X- and L-bands near the center of the image. Photographs of this area from the aircraft lead us to conclude that this area comprised bare surface thin ice such as nilas and gray ice surrounded by snow-covered first-year ice. Figure 4c shows a profile of the X-band, and Figure 4d a profile of the L-band, backscattering coefficients at an incidence angle of 50° using polarization as a parameter. Each value in the profile was an averaged value of 400 and 100 pixels (25m x 25m) in the X- and L-band image, respectively. The standard deviation of the backscattering coefficient was around ±1.5 dB

Fig. 4. Images of pi-sar (a) in the x-band, and (b) in the l-band, as color composites of hh (red), vv (green) and hv (blue). images correspond to square 2 in figure 2 and cover 5 km × 5 km. (c, d) profiles of backscattering coefficient of dashed lines (incidence angle of 50°) in (a)and(b), respectively, with polarization as parameter. the error bars are shown only at three distance points.

Figure 4c shows that the backscattering coefficient of the thin-ice area in VV polarization is > 8dB greater than that in HH polarization (polarization ratio: VV/ HH > 8dB), and 20 dB larger than that in HV polarization in the X-band (3.4−3.7 km distance). By contrast, in Figure 4d, the backscattering coefficients of the thin-ice area are very low (almost noise level) in all three polarization states in the L-band. Surface scattering may be dominant in this area. First-order surface scattering model calculations suggest that VV backscatter should exceed HH backscatter for smooth surface at this incidence angle (Reference Winebrenner, Tsang, Wen and WestWinebrenner and others, 1989). The corresponding mean VV/HH ratios at each frequency increase as the standard deviation of the surface height decreases and as the ice salinity and permittivity increase. These results suggest that the observed sea ice (3.4−3.7 km distance) was the thin ice having smoother surface and higher salinity than the surrounding first-year ice.

At distances of 2.5−3.0 km in Figure 4c, the backscattering coefficients of the cross-polarization HV of the thin-ice area were larger than those of the first-year ice area in the X-band. As the air temperature was higher than −10°C in the SAR observations, there was no multiple scattering caused by salt flowers on the sea-ice surface. This suggests that volume scattering and multiple scattering from the thin-sea-ice bodies cause large HV backscattering. However, at the typical salinity of thin sea ice, the dielectric constant is large (Reference Ulaby, Moore and FungUlaby and others, 1986). Thus, the penetration depth in the ice in the X-band is very small ( <1 cm), and the surface scattering appears to be the dominant cause of the backscattering mechanism. It is possible that there was thin ice with low salinity (several ppt) caused by the desalination of upper-level ice, which is subject to daily temperature changes. Model calculations for low-salinity ice and brine characteristics like these will be carried out in the near future.