A three-dimensional laminar-boundary-layer calculation is carried out over the area concerned. The external flow is simplified, being calculated by slender-body theory assuming conical flow, with two point vortices above the wing, their positions and strength being determined by experiment. Attempts are made to draw transition fronts both for two-dimensional and sweep instability from this calculation. The combination of these gives fronts similar to those observed in some experiments. Because there is little or no pressure gradient over the area in question it is suggested that it is a region where distributed suction might usefully be applied in order to maintain laminar flow and reduce drag.

The benefit to be obtained by using an interference fit between the pin and plate in a pin-jointed connection has already been established. An examination of the published results shows that some non-linearity occurs in the mechanism of load transference from the pin to the plate since, except at very high initial interference, doubling the load on the joint more than doubles the maximum shear stress in the plate. An examination of the stress-load relationship shows a distinct discontinuity, the load at which this discontinuity occurs being dependent upon both the initial interference and the coefficient of friction between the pin and the plate. It is shown that the results hitherto published correspond to a coefficient of friction between the pin and the plate of 0.3 and results for lower and higher coefficients are given.

A linearised, unsteady aerofoil theory is constructed which refers to an axis system which remains in the near vicinity of an aerofoil moving along an arbitrary flight path through a fluid at rest. The potential equation, the pressure equation and the boundary conditions at the aerofoil and in the wake are shown to be formally identical to those usually derived on the basis of an axis system translating uniformly through the fluid.

The paper presents a solution to the buckling of infinitely long plates clamped along the edges, together with an extension of the solution obtained by Stein and Fralich for the case when the edges are simply-supported. It is shown that, as a consequence of increasing the edge support from that of a simple support to one in which both deflection and rotation are prevented, the rigidity which an intermediate transverse stiffener must possess in order to support the plate effectively is much reduced. Agreement between the theoretical relationships and existing experimental data is good.

Results of a study of the accuracy attainable from various approaches to low aspect ratio wing deformational analyses are described. Seven model multi-web wings, representing a restricted range of sweep angles, aspect ratios and other geometric factors, were tested for deflection influence coefficients; Part I gave experimental data. This paper describes, applies, and compares certain elementary and plate bending theories. A subsequent paper will deal with discrete element idealisations commonly employed in matrix structural analysis.

Closed form solutions are given of the characteristic equation of the Hiigge theory with circumferential series expansion. Specialisations to simplified theories are shown.