Hostname: page-component-586b7cd67f-r5fsc Total loading time: 0 Render date: 2024-11-25T05:28:51.109Z Has data issue: false hasContentIssue false
  • English
  • Français

An Investigation of the Swirl in an S-Duct

Published online by Cambridge University Press:  07 June 2016

R.W. Guo  and
J. Seddon
R.W. Guo
Affiliation:
Department of Aeronautical Engineering, Bristol University; on sabbatical from Nanking Aeronautical Institute, China
J. Seddon
Affiliation:
Consultant to Department of Aeronautical Engineering, Bristol University
Get access

Summary

Measurements are presented of the static pressure, total pressure, swirl and three-dimensional turbulence in the flow through an S-curved rectangular duct mounted in a wind tunnel at different incidences, yaw angles and mass flow ratios. The results show that at high incidence there is a large vortex around an area of flow separation after the first bend and a pair of contra-rotating vortices in the flow after the second bend. The distortion of total pressure at the exit of the S-duct is significantly high, and the corresponding three-dimensional turbulence is up to 16.7%. Appreciation of the existence of this type of flow is important in the field of air intake design for jet aircraft.

Type
Research Article
Information
Aeronautical Quarterly , Volume 33 , Issue 1 , February 1982 , pp. 25 - 58
Copyright
Copyright © Royal Aeronautical Society. 1982

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Seddon, J. Air intake for aircraft gas turbines. J.R.Ae.Soc., October 1952 CrossRefGoogle Scholar
2 Bansod, P. and Bradshaw, P. The flow in S-shaped ducts. The Aeronautical Quarterly, 2, p 131, 1972 CrossRefGoogle Scholar
3 Rowland, C.J. Flow through curved ducts of constant cross section (S curve). Report No. 85, Dept of Aero. Eng., university of Bristol, June 1964 Google Scholar
4 Dunham, J. The generation of swirl in an S-duct. unpublished informationGoogle Scholar
5 Eiseman, P.R., Levy, R., McDonald, H. and Briley, W.R. Development of a three-dimensional turbulent duct flow analysis. NASA CR 3029, 1978 Google Scholar
6 Pratap, V.S. and Spalding, D.B. Numerical computations of the flow in curved ducts. The Aeronautical Quarterly, Vol. 26, Part 3, August 1975 CrossRefGoogle Scholar
7 Richard, J.R. An investigation of several NACA 1-Series inlets at Mach numbers from 0.4 to 1.29 for mass-flow ratios near 1.0. NASA TM X-3324Google Scholar