Solar powered aircraft are becoming more and more interesting for future long endurance missions at high altitudes, because they could provide Earth monitoring, telecommunications, etc. without any atmospheric pollution and, hopefully in the near future, with competitive costs compared with satellites. The research activities carried out till now have been mainly focused on flying wings or conventional aircraft configurations, with a great emphasis on the technological aspects. The present paper aims to define a mathematical model for solar powered aircraft preliminary design, valid independently of the aerodynamic configuration. A preliminary analysis is carried out in order to simulate Helios and the results are compared with those available from the flights of this aircraft. The proposed mathematical model is used also to compare four different aircraft configurations, namely: a flying wing, a conventional aircraft, a twin boom aircraft and a biplane aircraft. The results obtained are discussed in the paper and an optimum aircraft is analysed.

This paper describes a flight parameter based fatigue life analysis approach, which is developed for the Finnish Air Force F-18 fighters. It produces a flight specific fatigue life estimate for structural details using flight parameter data stored by each aircraft. Artificial neural networks are used to model structural response of analyzed details as a function of flight parameters. The analysis development is based on strain gauge data from 25 flights of an instrumented aircraft. The results show a satisfactory accuracy for the fatigue life estimates and prove the concept level analysis capability. The average difference between measured and modelled fatigue life is 21% for the fuselage bulkhead and 30% for the leading edge flap’s hinge area. The total differences in the Finnish Air Force average usage are extremely small, being –2% for the bulkhead and +2% for the leading edge flap.

A mathematical model was developed for the reversible longitudinal control system of a regional commuter aircraft using the available geometry, mass property and kinematics. The model was incorporated into a general multi-body dynamics code and validated using existing manufacturer’s data as well as recorded data from several flights. Analysis of the flight data revealed light atmosphere turbulence level. To investigate the effect of higher turbulence intensity on the reversible flight control system, a sever turbulence level was generated using Von Karman model for the same flight level and velocity. The result was used as a random input to the dynamic model for computation of the frequency response of control column. It was shown that turbulence could act as a random input through the hinge moment during the flight and introduced a new mode in the lower end of power spectral density curve. The energy induced by this low frequency input resulted in large displacement of control column in simulation which surpassed the existing limits. Therefore it should be taken into account when dealing with handling quality as well as autopilot design.

This work proposes an improved form of Menter’s single-equation eddy viscosity transport model. The new transport equation follows from the transformation of the k-ε closure that includes the Yap-correction term, which is known to improve the (k-ε) model’s prediction in adverse pressure gradient flows. The damping functions of the (low-Reynolds-number) LRN model are constructed using the ingenious approach of Baldwin and Barth. Hence, the model provides the correct wall-limiting behaviour of turbulence. Furthermore, the destruction term is modified to better account for non-equilibrium anisotropy effects. An assessment of the present proposed model against experiments, as well as Menter and Spalart-Allmaras (SA) turbulence models is provided via several boundary layer computations. Good agreement with experimental data is indicated, which merits the model to be considered for further refinement.

Steady non-vortex shedding base flow behind a bluff body is considered. Such a flow is characterised by the flow separation at the trailing edge of the body with an emerging shear layer which reattaches on the axis with strong recompression and recirculating flow bounded by the base, the shear layer, and the axis.

Steady wake flows behind a bluff body at low speeds have been studied for more than a century (for example, Kirchhoff; Riabouchinsky). Recently, research on steady bluff body wake flow at low speeds has been reviewed and reinterpreted by Roshko. Roshko has also commented on some basic aspects of steady supersonic base flow following on from Chapman and Korst analyses.

In the present paper, we examine the steady base flow features both at low speeds and supersonic speeds in the light of Roshko’s model and expand on some further aspects of base flows at supersonic and hypersonic speeds, not covered by Roshko.