Hostname: page-component-586b7cd67f-t8hqh Total loading time: 0 Render date: 2024-11-29T15:16:40.535Z Has data issue: false hasContentIssue false
  • English
  • Français

Realisation of the full potential of the laser doppler anemometer in the analysis of complex flows

Published online by Cambridge University Press:  04 July 2016

R. V. Barrett  and
C. Swales
R. V. Barrett
Affiliation:
Department of Aerospace EngineeringUniversity of BristolBristol, UK
C. Swales
Affiliation:
Department of Aerospace EngineeringUniversity of BristolBristol, UK
Get access Rights & Permissions [Opens in a new window]

Abstract

An improved method of alignment for the laser doppler anemometer has been developed which greatly enhances its capabilities for the examination of the often very small scale complexities of three-dimensional flows. Unlike the alignment methods normally employed, which are subjective, this method is quantitative, using a pin-hole device to measure laser light intensity. This ‘pin-hole meter’ also enables the geometry of the laser beam configuration to be defined in situ and with greater facility and precision than previous methods. Examples are given which illustrate the enhanced capability of the system, the greatest improvement coming from the ability to operate in the difficult to achieve and sustain, off-axis mode of signal collection. With this mode, the improved procedures enable very small measurement volumes, typically 50 micron diameter, while maintaining high data rates, in measurements taken from distances compatible with accessing the flow from outside the windtunnel.

Type
Research Article
Information
The Aeronautical Journal , Volume 102 , Issue 1016 , July 1998 , pp. 313 - 320
Copyright
Copyright © Royal Aeronautical Society 1998 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Drain, L.E. The Laser Doppler Technique, Wiley and Sons, 1980.Google Scholar
2. Durst, F., Melling, A. and Whitelaw, J.H. Principles and Practice of Laser Doppler Anemometry, Academic Press, 1976 Google Scholar
3. Swales, C., Rickards, J., Brake, C.J. and Barrett, R.V. Development of a pin-hole meter for aligning three dimensional laser doppler anemometers, Dantec Information, 12 February 1993.Google Scholar
4. Riley, A.J. Vortical Flows over Delta Wings, PhD thesis, University of Bristol, Department of Aerospace Engineering, August 1996.Google Scholar
5. MacManus, D., Eaton, J., Barrett, R.V., Rickards, J., Swales, C. Mapping the flow field induced by a HLFC perforation using a high resolution LDV, AIAA 96-0097, Proceedings of 34th Aerospace Sciences Meeting and Exhibition, Reno NV, USA, January 1996.Google Scholar
6. Lowson, M.V. Visualisation experiments of vortex flows, J Aircr, May 1991, 28, pp 320–327.Google Scholar
7. Barrett, R.V., Rickards, J., Swales, C. and Eustace, R.M. Use of laser doppler anemometry in the investigation of roughness particle induced transition on suction surfaces, Proceedings of 16th ICIASF Congress, Ohio, USA, July 1995.Google Scholar
8. Barrett, R.V., Rickards, J., Swales, C. and Brake, C.J. Enhanced performance of a cross-coupled three-dimensional laser doppler anemometer for small scale flow surveys using improved alignment and operational procedures, Proceedings of ICIASF ’93, Saint-Louis, USA, September 1993.Google Scholar
9. Swales, C. Advanced LDA Techniques for Measurement of 3D Boundary Layer Velocity Profiles on a Helicopter Rotor, PhD thesis, University of Bristol, Department of Aerospace Engineering, September 1994.Google Scholar
10. Nash, E.C. Boundary Layer Instability Noise on Aerofoils, PhD Thesis, University of Bristol, Department of Aerospace Engineering, August 1996.Google Scholar