Hostname: page-component-586b7cd67f-t7czq Total loading time: 0 Render date: 2024-11-27T05:45:07.226Z Has data issue: false hasContentIssue false
  • English
  • Français

The Use of Proton-Excited X-Ray Emission to Study: 1) Electrodeposited TiB2 Coatings and 2) Gas-Turbine Blade Failures

Published online by Cambridge University Press:  06 March 2019

B. D. Sartwell  and
P. B. Needham Jr.
B. D. Sartwell
Affiliation:
Bureau of Mines, U.S. Department of the Interior College Park, Maryland 20740
P. B. Needham Jr.
Affiliation:
Bureau of Mines, U.S. Department of the Interior College Park, Maryland 20740
Get access

Abstract

A method to quantitatively analyze the surface regions of metals, alloys, and coatings using proton-excited X-ray emission (PEX) has been utilized in two areas of metallurgy research. This paper describes application of the technique to (1) the development of erosion- and corrosion-resistant coatings, and (2) the study of structural failures in turbine alloys.

The technology for the electrodeposition of erosion- and corrosionresistant TiB2 coatings from molten-salt electrolytes has been developed in order to provide protective coatings for valve components in coal gasification plants. Analyses by PEX and X-ray diffraction have played the key role in the determination of the optimum electrolysis parameters required to obtain adherent, erosion-resistant TiB2 coatings. From these studies, the erosion resistance of a TiB2 coating can be predicted on the basis of (1) the amount of Cr and Fe impurities codeposited during electrolysis and (2) the degree of orientation of the TiB2 crystal structure along the (110) or (100) planes.

PEX was used for analytical studies of a Nimonic 105 alloy turbine blade and an A-286 alloy turbine wheel from a San Diego, California, power generating station gas turbine that suffered a catastrophic failure in November 1974. Analyses of the turbine blade in the region at which the rupture occurred showed alloy composition changes that included decreases of 80%, 78%, 52%, and 50% of Al, Ti, Cr, and Co, respectively, and an increase of 2500% in Fe. Alloy composition changes were also found at the failure interface of the turbine wheel; these included decreases of 43%, 21%, and 15% in Hi, Cr, and Ti, respectively, and increases of 248% and 714% in Si and Al, respectively.

Type
X-Ray Fluorescence Phenomena and Application
Information
Advances in X-Ray Analysis , Volume 19: Twenty-Fourth Annual Conference on Applications of X-ray Analysis, August 6-8, 1975 , 1975 , pp. 293 - 303
Copyright
Copyright © International Centre for Diffraction Data 1975

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Sterk, A. A., “X-Ray Generation by Proton Bombardment,” in Mueller, W. M., Mallett, G. R., and Fay, M. J., Editors, Advances in X-Ray Analysis, Vol. 8, p. 189–197, Plenum Press (1964).Google Scholar
2. Christensen, L. J., Khan, J. M., and Brunner, W. F., “Measurement of Microgram Surface Densities by Observation of Proton Produced X-Rays,” Rev. Scientific Instruments 38, 20 (1967).Google Scholar
3. Hart, R. R., Olson, N. T., and Smith, H. P., “Oxygen Surface-Density Measurements Based on Characteristic X-Ray Production by 100-keV Protons,” Journal of Applied Physics 39, 5538 (1968).Google Scholar
4. Hart, R. R., Reuter III, F. W., and Smith, H. P. Jr., “Oxygen K-Shell X-Ray Production in Thin Films of Aluminum Oxide by 20 to 100 keV Protons,” Phys. Rev. 179, 164 (1969).Google Scholar
5. Needham, P. B. Jr., and Sartwell, B.D., “X-Ray Production Efficiencies for K-, L-, M-, and N-Sbell Excitation by Ion Impact,” in Barrett, C. S., Newkirk, J. B., and Ruud, C. O., Editors, Advances in X-Ray Analysis, Vol. 14, p. 184–213, Plenum Press (1971).Google Scholar
6. Needham, P. B. Jr., Leavenworth, H. W., and Driscoll, T. J., “The Kinetics of Thin Oxide Film Formation on Iron Using Proton-Excited X-Ray Analysis,” J. of Electrochemical Society 120, 778 (1973).Google Scholar
7. Musket, R. G. and Bauer, W., “Surface Analysis Using Proton Beams,” Thin Solid Films 19, 69, (1973).Google Scholar
8. Meedham, P. B. Jr., Driscoll, T. J., and Rao, N. G., “Correlation of Fractional-Monolayer Oxygen Determinations Obtained by Proton- Excited X-Ray and Auger Electron Spectroscopy Analysis of Fe Surfaces,” Applied Phys. Letters 21, 502 (1972).Google Scholar
9. Private communication with David Mulliner, K., San Diego Gas&Electric Company.Google Scholar