Hostname: page-component-78c5997874-lj6df Total loading time: 0 Render date: 2024-11-05T01:47:57.050Z Has data issue: false hasContentIssue false

Effect of Powder Sample Granularity on Fluorescent Intensity and on Thermal Parameters in X-Ray Diffraction Rietveld Analysis

Published online by Cambridge University Press:  06 March 2019

C. J. Sparks
Affiliation:
Oak Ridge National Laboratory P.O. Box 200S Oak Ridge, Tennessee 37831-6118
R. Kumar
Affiliation:
Oak Ridge National Laboratory P.O. Box 200S Oak Ridge, Tennessee 37831-6118
E. D. Specht
Affiliation:
Oak Ridge National Laboratory P.O. Box 200S Oak Ridge, Tennessee 37831-6118
P. Zschack
Affiliation:
Oak Ridge National Laboratory P.O. Box 200S Oak Ridge, Tennessee 37831-6118
G. E. Ice
Affiliation:
Oak Ridge National Laboratory P.O. Box 200S Oak Ridge, Tennessee 37831-6118
T. Shiraishi
Affiliation:
Oak Ridge National Laboratory P.O. Box 200S Oak Ridge, Tennessee 37831-6118
K. Hisatsune
Affiliation:
Oak Ridge National Laboratory P.O. Box 200S Oak Ridge, Tennessee 37831-6118
Get access

Abstract

The effect of sample granularity on diffracted x-ray intensity was evaluated by measuring the 2θ dependence of x-ray fluorescence from various samples. Measurements were made in the symmetric geometry on samples ranging from single crystals to highly absorbing coarse powders. A characteristic shape for the absorption correction was observed. A demonstration of the sensitivity of Rietveld refined site occupation parameters is made on CuAu and Cu50Au44Ni6 alloys refined with and without granularity corrections. These alloys provide a good example of the effect of granularity due to their large linear x-ray absorption coefficients. Sample granularity and refined thermal parameters obtained from the Rietveld analysis were found to be correlated. Without a granularity correction, the refined thermal parameters are too low and can actually become negative in an attempt to compensate for granularity, A general shape for granularity correction can be included in refinement procedures. If no granularity correction is included, data should be restricted to above 30° 2θ, and thermal parameters should be ignored unless extreme precautions are taken to produce <5 (μm particles and high packing densities.

Type
I. Whole Pattern Fitting, Rietveld Analysis and Calculated Diffraction Patterns
Copyright
Copyright © International Centre for Diffraction Data 1991

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Borie, B., 1981, An estimate of the surface roughness effect, J. Appl. Cryst. 14: 219.Google Scholar
Brindley, G.W., 1945, The effect of grain or particle size on X-ray reflections from mixed powders and alloys, considered in relation to the determination of crystalline substances by X-ray methods, Phil. Mag. 36: 347.Google Scholar
Claisse, F. and Samson, C., 1962, Heterogeneity Effects in X-Ray Analysis, in: “Advances in X-Ray Analysis” W. M. Mueller ed., Plenum Press, NY, p.335.Google Scholar
Hermann, H.,and Ermrich, M., Microabsorption of X-ray intensity in randomly packed powder specimens, 1989, Microabsorption correction of x-ray intensities diffracted by multiphase powder specimens, Powder Diffr. 4: 189.Google Scholar
Hermann, H., and Ermrich, M. 1987, Acta Cryst. A43: 401.Google Scholar
Kumar, R., Sparks, C.J., Shiraishi, T., Specht, E.D., Zschack, P., Ice, G.E., and Hisatsune, K., 1991, X-ray determination of site occupation parameters in ordered ternaries Cu(AuxM1-x), M = Ni, Pd, Mater. Res. Soc. Symp. Proc. 213: 369.Google Scholar
Larson, A. C, and Von Dreele, R.B., 1989, Los Alamos National Laboratory Report No. LAUR86-748.Google Scholar
Parrish, W., and Hart, M., 1988, Accurate measurements of powder diffraction intensities using synchrotron radiation, Aust. J. Phys. 41: 403.Google Scholar
Sparks, C.J., 1976, Quantitative x-ray fluorescent analysis using fundamental parameters, in: “Advances in X-Ray Analysis,” R. Gould et al., eds., Kendali/Hunt, Dubuque, Iowa, p. 19.Google Scholar
Suortti, P., and Jennings, L.D., 1977, Accuracy of structure factors from x-ray powder intensity measurements, Acta Cryst. A33: 1012,Google Scholar
Wolff, P.M. Measurement of particle absorption by X-ray Fluorescence, 1956, Acta Cryst. 9: 682.Google Scholar