Hostname: page-component-78c5997874-t5tsf Total loading time: 0 Render date: 2024-11-09T08:00:26.012Z Has data issue: false hasContentIssue false
  • English
  • Français

Real Time Synchrotron Topography Using a CID Array Camera with Digital Image Acquisition and Processing

Published online by Cambridge University Press:  06 March 2019

John M. Winter  and
Robert E. Green Jr.
John M. Winter
Affiliation:
Center for Nondestructive Evaluation The Johns Hopkins University Baltimore, MD 21218
Robert E. Green Jr.
Affiliation:
Center for Nondestructive Evaluation The Johns Hopkins University Baltimore, MD 21218
Get access

Extract

Synchrotron white beam transmission topography of GaAs as previously reported by the authors relied on scanning specimen and film synchronously through the incident x-ray beam to record transmission topographic images en film. Sometimes the total dose required for reasonable contrast on film carried with it enough thermal deposition to cause elastic warping of the wafer. To escape these problems, a real time system was assembled. This system included an image intensifier, a solid state camera, a computer board to frame-grab and digitize images, and appropriate image processing software. With this system, a three inch specimen was scanned from edge to edge in one minute. At this scan rate, the incident x-ray beam had to be significantly attenuated to avoid saturating the intensifier output.

Type
III. Applications of Diffraction to Semiconductors and Films
Information
Advances in X-Ray Analysis , Volume 38: Forty-third Annual Conference on Applications of X-ray Analysis , 1994 , pp. 215 - 219
Copyright
Copyright © International Centre for Diffraction Data 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Winter, J.M. Jr., Green, R.E., Jr., and Green, K.A., “Application of Synchrotron and Flash X-Ray Topography to Improved Processing of Electronic Materials”, Advances in X-Ray Analysis, 35A, pp 239–245, Barrett, C.S., et. al. eds., Plenum Press, N.Y., (1992).Google Scholar
2. Winter, J, M. Jr., and Green, R. E., Jr., “Thermally Induced Strain in Gallium Arsenide as Observed in White Beam Transmission Topography”, in Annual Report of the National Synchrotron Light Source, Brookhaven National Laboratory, Upton, New York, p. 303, (1990).Google Scholar
3. Model, CID.E. 2250D2-20 Camera, CID Technologies, Inc., Box, P.O. 626, Liverpool, N.Y., 13088Google Scholar
4. DT3851A-8 Flexible Frame Processor Board, Data Translation, 100 Locke Drive, Marlboro, MA, 01752Google Scholar
5. Model 4DX2-66V computer with a VESA Local Bus, an ATI Ultra Pro graphics accelerator card, 8 Mb of RAM, a 256 Kb cache, a 340 Mb hard disk drive, and both 5.25” and 3.5” floppy disk drives, Gateway 2000, 610 Gateway Drive, North Sioux City, South Dakota.Google Scholar