If plasmas are considered fully ionized, the electronic stopping of a charged particle that traverses them will only be due to free electrons. This stopping can be obtained in a first view through the random phase approximation (RPA). But free electrons interact between them affecting the stopping. These interactions can be taken into account in the dielectric formalism by means of two different ways: the Mermin function or the local field corrections (LFCs). LFCs produce an enhancement in stopping before the maximum and recover the RPA values just after it. Mermin method also produces firstly a high increase at very low energies, then a small enhancement at low energies and finally decreases below RPA values before and after the maximum. Differences between the two methods are very important at very low energies and by 30% around the stopping maximum.

We analyze the results of a recent experiment performed at the PALS laboratory and concerning ablation pressure at 0.44 µm laser wavelength measured at irradiance up to 2 × 1014 W/cm2. Using the code “ATLANT,” we have performed two-dimensional (2D) hydrodynamics simulations. Results show that 2D effects did not affect the experiment and also give evidence of the phenomenon of delocalized absorption of laser light.

The charge on plasma ions may fluctuate due to random ionization and recombination processes. The resulting motion has a time dependent Hamiltonian and in simple cases, the ions steadily gain energy. Quantitative rates are estimated for some cases involving high Z plasmas.

For operation of an ion source in an intense ion beam diode, it is desirable to form a localized and robust source of high purity. A cryogenically operated ion source has great promise, since the ions are formed from a condensed high-purity gas, which has been confined to a relatively thin ice layer on the anode surface. Previous experiments have established the principles of operation of such an ion source, but have been limited in repetitive duration due to the use of short-lived liquid He cooling of the anode surface. We detail here the successful development of a “Cryo-Diode” in which the cooling was achieved with a closed-cycle cryo-pump. This results in an ion source design that can potentially be operated for an indefinite duration. Time-of-flight measurements with Faraday cups indicate that the resultant ion beam is of high-purity, and composed of singly charged ions formed out of the gas frozen out on the anode surface.

The evolution of a high-density electron beam in the field of a super-intense laser pulse is considered. The one-dimensional (1D) theory for the description of interaction, taking into account the space-charge forces of the beam, is developed, and exact solutions for the equations of motion of the electrons are found. It was shown that the length of the high-density electron beam increases slowly in time after initial compression of the beam by the laser pulse as opposed to the low-density electron beam case, where the length is constant on average. Also, for the high-density electron beam, the sharp peak frozen into the density distribution can appear in addition to a microbunching, which is characteristic for a low-density electron beam in a super-intense laser field. Characteristic parameters for the evolution of the electron beam are calculated by an example of a step-like envelope of the laser pulse. Comparison with 1D particle-in-cell simulations shows adequacy of the derived theory. The considered issue is very important for a special two-pulse realization of a Thomson scattering scheme, where one high-intensity laser pulse is used for acceleration, compression and microbunching of the electron beam, and the other probe counter-streaming laser pulse is used for scattering with frequency up-shifting and amplitude enhancement.

The ablation of calcium sample has been studied by the optical emission spectroscopy of the evolving plasma using the fundamental, second, and third harmonic of a Nd:YAG laser, which reveals numerous transitions due to neutral and singly ionized calcium. The measurements have been performed to determine the electron temperature and electron number density and their spatial behavior. In addition, the behavior of the electron temperature and number density as a function of laser irradiance and ambient gas pressure has been studied. The processes of laser photon absorption in the plasma through inverse bremsstrahlung and photoionization have also been discussed.

Angular distributions of currents and velocities (energies) of ions produced at various target irradiation angles and laser intensities ranged from 1010 W/cm2 to 1017 W/cm2 were analyzed. It was confirmed that for low laser intensities the ion current distributions are always peaked along the target normal. However, at laser intensities comparable to or higher than 1014 W/cm2, the preferred direction of ion emission strongly depends on the irradiation geometry (laser focus setting, the irradiation angle), and can be off the target normal. This is very likely caused by the non-linear interaction of the laser beam with produced plasma, in particular, by the action of ponderomotive forces and the laser beam self-focusing.

This paper is devoted to investigations of laser energy transfer into solid targets with respect to the focusing lens focal point position relative to the solid target surface as obtained at the PALS laser facility. The third harmonic of the PALS laser beam with energy ~90 J and pulse duration ~250 ps (FWHM) was used for irradiation of two kinds of targets made of Cu: a slab and a 3.6 µm thick foil. The focal point of the beam was located either inside or in front of the target surface, and care was taken to ensure the same laser spot radii in both cases (250 µm). It was demonstrated that these two opposite focal point positions give rise to significantly different laser-plasma interactions: with either depression or maximum of the laser intensity distribution in the center of the beam, respectively. It was also verified that the focal point position inside of the target is favorable for plasma jets creation, whereas the opposite case is more effective for acceleration of flyers.

Extensive numerical simulations have been carried out to design a viable solid graphite wheel shaped production target for the super conducting fragment separator experiments (Super-FRS) at the future Facility for Antiprotons and Ion Research (FAIR) using an intense uranium beam. In this study, generation, propagation and decay of deviatoric stress waves induced by the beam in the target, have been investigated. Maximum beam intensities that the target can tolerate using different focal spot sizes that are determined by requirements of good isotope resolution and transmission of the secondary beam through the fragment separator, have been calculated. It has been reported elsewhere that the tensile strength of graphite significantly increases with temperature. To take advantage of this effect, calculations have also been done in which the target is preheated to a higher temperature, that in practice can be achieved, for example, by irradiating the target with a defocused ion beam before the experiments are performed. We report results of a few examples using an initial temperature of 2000 K. This study has shown that employing such a configuration, one may use a solid graphite production target even for the maximum intensity of the uranium beam (5 × 1011 ion per bunch) at the Super-FRS.

A kinetic model of electron cascade growth in the electromagnetic field of a focused intense laser pulse as used for laser spark generation in gases has been numerically implemented in Visual C code. The effects considered comprise Drude absorption, diffusive kinetic and inelastic losses as well as (three-particle) electron recombination. The objectives were to illustrate the dynamic process of gas ionization, and to clarify the pressure dependence of known breakdown thresholds within a range of about 2 × 104 to 2 × 106 Pa of initial pressure. Two-dimensional (cylindric coordinates) simulations of the optical breakdown in nitrogen were conducted on a commercial PC, using constant values for the collision cross section (2 × 10−19 m2), prevalent electronic excitation states (~4.8 eV), and a laser wavelength of 1064 nm. A certain aerosol concentration on the order of 3 ppb was assumed in order to provide initial electrons for cascade growth. Exemplary results with laser pulse energy of 26 mJ, pulse duration of 14 ns and an 18 µm focal spot size illustrate the dynamic process of ionization within a very short time period of less than 0.5 ns. The kinetic energy of the electrons is found to increase sharply up to more than 100,000 K on breakdown. A series of simulations considered the minimum pulse energy of breakdown (MPE) under variation of initial pressure. Identical laser parameters as in experiments conducted previously were used and the results are in excellent agreement with respect to curve shapes, i.e., MPE ~1/p0.4 in the first experiment and MPE ~1/p0.3 in the second one. The absolute values lie within a factor of two, which is explained by model abstraction and input data uncertainties.

This paper deals with the study of propagation of electromagnetic wave in a rectangular waveguide filled with an inhomogeneous plasma in which electron density varies linearly in a transverse direction to the mode propagation. A transcendental equation in ω (microwave frequency) is obtained that governs the mode propagation. In addition, an attempt is made to examine the effect of density inhomogeneity on the energy gain acquired by the electron (electron bunch) when it is injected in the waveguide along the direction of the mode propagation. On the basis of angle of deflection of the electron motion we optimize the microwave parameters so that the electron does not strike with the waveguide walls. Conditions have been discussed for achieving larger energy gain. The plasma density inhomogeneity is found to play a crucial role on the cutoff frequency, fields and dispersion relation of the TE10 mode as well as on the acceleration gradient in the waveguide.

Resonant acceleration of plasma electrons in combined circularly polarized Gaussian laser fields and self-generated quasistatic fields has been investigated theoretically and numerically. The latter includes the radial quasistatic electric field, the azimuthal quasistatic magnetic field and the axial one. The resonant condition is theoretically given and numerically testified. The results show some of the resonant electrons are accelerated to velocities larger than the laser group velocity and thus gain high energy. For peak laser intensity I0 = 1 × 1020 W cm−2 and plasma density n0 = 0.1ncr, the relativistic electron beam with energies increased from 207 MeV to 262 MeV with a relative energy width around 24% and extreme low beam divergence less than 1° has been obtained. The effect of laser intensity and plasma density on the final energy gain of resonant electrons is also investigated.

The measurement of charged particles and cavitation bubble expansion velocity is reported in a laser induced breakdown in water using beam deflection set-up. Effect of laser power on charged particles, cavitation bubble velocities and higher order bubble oscillations is also studied.

Interactions of cone targets with different shapes with laser pulses are studied numerically. Two important parameters which characterize the laser-cone interaction in 2006 are introduced, which are cone angle and ratio of laser spot and cone tip. By changing these two parameters, energy coupling from laser to electrons is controlled. Some fraction of high energy electrons generated at side wall and cone tip are not freely propagating out from the target, but confined around the cone tip due to the disturbed electric field.

The KrF laser has been considered as an inertial fusion driver alternative to diode-pumped lasers. The possibilities of KrF lasers for fast ignition is supported by their short wavelength and the corresponding larger penetration depth together with the possible use of the same amplifiers for fusion driver and fast ignitor. It is shown that in the case of a fusion test facility both the energy and the intensity requirements can be fulfilled. A fast ignitor using 20 ps KrF pulses requires beam smoothing techniques after angular multiplexing due to the coherence of the beam. A multiple beam fast ignitor is suggested as an alternative in which a high number of beams of 1 ps duration are separately focused on the fuel after polarization demultiplexing. This arrangement allows even the pulse-forming of the ignitor.

In the present investigation, the excitation of an upper hybrid wave (UHW) in a hot collisionless magneto-plasma by a relativistic laser beam propagating perpendicular to the static magnetic field and having its electric vector polarized along the direction of the static magnetic field (ordinary mode) is presented. Due to nonuniform intensity distribution of pump laser, the background electron concentration is modified. The amplitude of the UHW, which depends on the background electron concentration, is thus nonlinearly coupled with the laser beam. The effect of nonlinear coupling between the pump laser and UHW is studied. The effect of the relativistic electron mass nonlinearity and the relativistic self-focusing of the pump laser on the excitation of the UHW have been incorporated. The dynamics of the excitation of the UHW in different power domains of the laser beam is accordingly modified. It has been seen that the effect of changing the strength of the static magnetic field on the nonlinear coupling and the dynamics of the excitation of the UHW is significant. The focusing behavior of the UHW may find its relevance in the heating of plasmas near the upper hybrid resonance.

Radiative properties are fundamental for plasma diagnostics and hydro-simulations. For this reason, there is a high interest in their determination and they are a current topic of investigation both in astrophysics and inertial fusion confinement research. In this work a flexible computation package for calculating radiative properties for low and high Z optically thin and thick plasmas, both under local thermodynamic equilibrium and non-local thermodynamic equilibrium conditions, named RAPCAL is presented. This code has been developed with the aim of providing accurate radiative properties for low and medium Z plasmas within the context of detailed level accounting approach and for heavy elements under the detailed configuration accounting approach. In order to show the capabilities of the code, there are presented calculations of some radiative properties for carbon, aluminum, krypton and xenon plasmas under local thermodynamic and non-local thermodynamic equilibrium conditions.

In order to restrain the prepulse of a high energy fluence diode, a flash-over switch made of a nylon cylinder was inserted in between the cathode stalk and the cathode. Secondary prepulse technique was developed to lower the flash-over voltage of the switch. It was found that the surface resistivity of the nylon insulator changes considerably after each shot and this resistivity on the order of 107 Ω/m is most suitable for a 20-mm long flash-over switch to operate stably at a lower flash-over voltage.

This paper describes a fast multi-channel radiation pyrometer that was developed for warm dense-matter experiments with intense heavy ion beams at the Gesellschaft für Schwerionenforschung mbH (GSI). The pyrometer is capable of measuring brightness temperatures from 2000 K to 50,000 K, at six wavelengths in the visible and near-infrared parts of the spectrum, with 5 ns temporal resolution, and several micrometers spatial resolution. The pyrometer's spectral discrimination technique is based on interference filters, which also act as mirrors to allow for simultaneous spectral discrimination of the same ray at multiple wavelengths.

We used X-ray spectroscopy as a diagnostic tool for investigating the properties of laser-cluster interactions at the stage in which non-adiabatic cluster expansion takes place and a quasi-homogeneous plasma is produced. The experiment was carried out with a 10 TW, 65 fs Ti:Sa laser focused on CO2 cluster jets. The effect of different laser-pulse contrast ratios and cluster concentrations was investigated. The X-ray emission associated to the Rydberg transitions allowed us to retrieve, through the density and temperature of the emitting plasma, the time after the beginning of the interaction at which the emission occurred. The comparison of this value with the estimated time for the “homogeneous” plasma formation shows that the degree of adiabaticity depends on both the cluster concentration and the pulse contrast. Interferometric measurements support the X-ray data concerning the plasma electron density.