In this article, we demonstrate the generation of four phase-locked harmonic pulses separated in time using frequency-domain interferometry. The spectra present a high sensitivity to a change of the relative phase on an attosecond time scale. The spectral resolution and the control of this relative phase could be used to perform high resolution measurements.

Effective ion acceleration of picosecond-duration well-collimated bunches in the strong relativistic interaction of a short laser pulse with a thin solid target has been experimentally demonstrated. In this work, with reference to the sharp rear solid–vacuum interface, where ion energization takes place, the one-dimensional Poisson–Boltzmann equation is analytically solved on a finite spatial interval whose extension is determined by requiring electron energy conservation, resulting in the consistent spatial distributions of the hot electrons created by the laser and of the corresponding electrostatic potential. Then, the equation of motions for an ensemble of test ions, initially distributed in a thin layer of the rear target surface, with different initial conditions, is solved and the energy spectrum corresponding to a given initial ion distribution is determined.

Experimental investigations of heavy-ion-generated shock waves in solid, multilayered targets were performed by applying a Schlieren and a laser-deflection technique. Shock velocity and the corresponding pressures, temporal and spatial density profiles inside the material compressed by multiple shock waves, and details of the shock dynamics were determined. Important for equation-of-state and phase transition studies, such experiments extend their relevance to inertial confinement fusion and astrophysical fundamental research.

We report on the results concerning the characteristics and the behavior of expanding plasma generated by a Laser Ion Source (LIS). The LIS technique is an efficient means in producing of multi-charged ions utilizing pulsed laser beams. In order to extract Cu ions, in this experiment an XeCl excimer UV laser was employed, providing a power density on the target surface up to 5 × 108 W/cm2. Two typologies of diagnostic systems were developed in order to detect the plasma current and the ion energy. The time-of-flight (TOF) measurements were performed exploiting either a Faraday cup or an Ion Energy Analyzer (IEA). This latter allowed getting quantitative information about the relative ion abundances, their kinetic energy and their charge state. To study the plasma characteristics we measured the total etched material per pulse at 70 mJ. It was 0.235 μg and the overall degree of ionization, 16%. The angular distribution of the ablated material was monitored by optical transmission analysis of the deposited film as a function of the angle with respect to the normal to the target surface. Applying a high voltage to an extraction gap a multi-charged ion beam was obtained; different peaks could be distinguished in the TOF spectrum, resulting from the separation of ions of hydrogen, adsorbed compounds in the target and copper.

The article presents the multigroup kinetic approximation of radiation transport in hohlraum systems. The view factor-based method of numerical solution is proposed. Its advantages are a detailed account of the problem geometry and accurate handling of the solution angular anisotropy and discontinuities. The method is computationally efficient and easily parallelizable. Coupled to the kinetic + hydro description of the wall dynamics, it represents a powerful tool for integrated investigation of the systems with strongly inhomogeneous optical properties.

The application of selective resonant tunneling model is extended from d + t fusion to other light nucleus fusion reactions, such as d + d fusion and d + 3He. In contrast to traditional formulas, the new formula for the cross-section needs only a few parameters to fit the experimental data in the energy range of interest. The features of the astrophysical S-function are derived in terms of this model. The physics of resonant tunneling is discussed.

A XUV Michelson interferometer has been developed by LIXAM/CEA/LCFIO and has been tested as a Fourier-transform spectrometer for measurement of X-ray laser line shape. The observed strong deformation of the interference fringes limited the interest of such an interferometer for plasma probing. Because the fringe deformation was coming from a distortion of the beam splitter (5 × 5 mm2 open aperture, about 150 nm thick), several parameters of the multilayer deposition used for the beam splitter fabrication have been recently optimized. The flatness has been improved from 80 nm rms obtained by using the ion beam sputtering technique, to 20 nm rms by using the magnetron sputtering technique. Over 3 × 3 mm2, the beam splitter has a flatness better than 4 nm rms.

Foams are an important component of various inertial confinement fusion target schemes. The propagation of shock waves in foams is also an important issue for many other laser experiments (e.g., laboratory astrophysics experiments). The usual approach is to assume that the foam can be considered as a homogeneous mixture. Taking into account the effects of foam heterogeneity leads to increased shock velocity and reduced compressibility. Evidence of this effect is obtained using two-dimensional adaptive mesh refinement Eulerian numerical simulations. Nonetheless, for the very low density foams filled with DT ice used in recent direct drive target designs, the homogeneous mixture model provides adequate shock timing, density, and pressure profiles.

We consider ion acceleration at the front surface of overdense plasma by a short laser pulse. In this configuration, the laser ponderomotive pressure pushes the background electrons, and a double layer is produced at the boundary of the overdense region. The ions are accelerated by the electrostatic field of the double layer. If the laser intensity is so large that the plasma becomes relativistically transparent, then ion trapping in the running double layer and acceleration to relativistic energies is possible. We study this physics using one-dimensional particle-in-cell simulations. Ion acceleration in one- and two-component plasmas is considered. It is shown that the proton acceleration is more effective when they represent only a small dope to the heavy background ions.

Ultrashort pulsed hard X rays are generated by focusing an intense femtosecond laser beam onto metal targets. Kα emissions are obtained from a Cu target. Picosecond time-resolved X-ray diffraction is performed to investigate structural dynamics of laser-shocked semiconductors using the laser plasma X-ray pulses. Lattice deformation associated with shock-wave propagation is directly observed. Evolution of strain profiles inside the crystal is determined without disturbance from the time-resolved X-ray diffraction patterns.

This article presents a numerical and theoretical study of the generation and propagation of oscillation in the semiclassical limit ħ → 0 of the nonlinear paraxial equation. In a general setting of both dimension and nonlinearity, the essential differences between the “defocusing” and “focusing” cases are observed. Numerical comparisons of the oscillations are made between the linear (“free”) and the cubic (defocusing and focusing) cases in one dimension. The integrability of the one-dimensional cubic nonlinear paraxial equation is exploited to give a complete global characterization of the weak limits of the oscillations in the defocusing case.

Quantum effects in spontaneous and stimulated Compton laser-beam interactions are considered in the frame of the Klein–Gordon theory. We derive a quantum kinetic equation to describe the laser cooling of electron beams. Nonlinear theory of coherent π-pulse generation in the quantum X-ray Compton FEL is presented. A scheme of coherent stimulated annihilation of electron-positron pairs and stimulated emission of γ-ray photons is proposed.

New easy spectrally tunable backlighting schemes based on a spherically bent crystal are considered. Contrary to traditional backlighting scheme, in which the investigated objects should be placed between the backlighter and the crystal, for the considered schemes an object is placed downstream of the crystal, before the tangential or after the sagittal focus and an image of the object is recorded at the distance from the object corresponding to the needed magnification. The magnification is defined by the ratio of the distances from the sagittal focus to the detector and from the object to the sagittal focus. A ray-tracing modeling and experimental images of test meshes, obtained at incidence angles of the backlighter radiation of 10° and 22°, are presented. It is demonstrated that a simple linear transformation of the obtained astigmatic images allows reconstructing them as a stigmatic with an accuracy of 5–15%. For the spectral range around 9 Å a spatial resolution about 10 μm in a field of view of some square millimeters is achieved experimentally and confirmed by ray-tracing simulations.

This article reports on experimental studies of subnanosecond electron beams formed in air under atmospheric pressure. An electron beam with an amplitude of ∼170 A with a duration at FWHM of ∼0.3 ns has been obtained. Based on beam temporal characteristics and discharge spatial characteristics, the critical fields were supposed to be reached at plasma approach to anode. Simultaneously, the sharp high-energy pulse of e-beam current is generated. Of critical importance is the cathode type and occurrence on the cathode of plasma protrusions. It is shown that to get maximum amplitude of the electron beam in the gas diode, the discharge in the gas diode should be volumetric.

A one-dimensional model for a laser-ablated slab under acceleration g is developed. A characteristic value gc is found to separate two solutions: Lower g values allow sonic or subsonic flow at the critical surface; for higher g the sonic point approaches closer and closer to the slab surface. A significant reduction in the ablation pressure is found in comparison to the g = 0 case. A simple dependence law between the ablation pressure and the slab acceleration, from the initial value g0 to infinity, is identified. Results compared well with fully hydrodynamic computer simulations with Multi2D code. The model has also been found a key step to produce indefinitely steady numerical solutions to study Rayleigh–Taylor instabilities in heat ablation fronts, and validate other theoretical analysis of the problem.

The Gesellschaft für Schwerionenforschung (GSI) Darmstadt has been approved to build a new powerful facility named FAIR (Facility for Antiprotons and Ion Research) which involves the construction of a new synchrotron ring SIS100. In this paper, we will report on the results of a parameter study that has been carried out to estimate the minimum pulse lengths and the maximum peak powers achievable, using bunch rotation RF gymnastic-including nonlinearities of the RF gap voltage in SIS100, using a longitudinal dynamics particle in cell (PIC) code, ESME. These calculations have shown that a pulse length of the order of 20 ns may be possible when no prebunching is performed while the pulse length gradually increases with the prebunching voltage. Three different cases, including 0.4 GeV/u, 1 GeV/u, and 2.7 GeV/u are considered for the particle energy. The worst case is for the kinetic energy of 0.4 GeV/u which leads to a pulse length of about 100 ns for a prebunching voltage of 100 kV (RF amplitude). The peak power was found to have a maximum, however, at 0.5–1.5kV prebunching voltage, depending on the mean kinetic energy of the ions. It is expected that the SIS100 will deliver a beam with an intensity of 1–2 × 1012 ions. Availability of such a powerful beam will make it possible to study the properties of high-energy-density (HED) matter in a parameter range that is very difficult to access by other means. These studies involve irradiation of high density targets by the ion beam for which optimization of the target heating is the key problem. The temperature to which a target can be heated depends on the power that is deposited in the material by the projectile ions. The optimization of the power, however, depends on the interplay of various parameters including beam intensity, beam spot area, and duration of the ion bunch. The purpose of this paper is to determine a set of the above parameters that would lead to an optimized target heating by the future SIS100 beam.

Measurements of the ion emission from targets irradiated with neodymium glass and iodine lasers were analyzed and a very significant anomaly observed. The fastest ions with high charge number Z, which usually are of megaelectron volt energy following the relativistic self-focusing and nonlinear-force acceleration theory, were reduced to less than 50 times lower energies when 1.2 ps laser pulses of about 1 J were incident. We clarify this discrepancy by the model of skin depth plasma front interaction in contrast to the relativistic self-focusing with filament generation. This was indicated also from the unique fact that the ion number was independent of the laser intensity. The skin layer theory prescribes prepulse control and lower (near relativistic threshold) laser intensities for nonlinear-force-driven plasma blocks for high-gain ignition similar to light ion beam fusion.

Recent results on constructing of an efficient hard X-ray source using solid targets irradiated by high-contrast 200-fs laser pulses with an intensity above 1016 W/cm2 are presented. We used different solid targets with a laser- and electrochemically modified surface layer: craters, pyramidal cavities, porous silicon, gratings. Experimental data obtained confirms that using solid targets with a corrugated surface one can achieve a prominent increase both in the efficiency of hard X-ray generation (in the quanta range 2–30 keV) and in the hot electron temperature of plasma.

The forthcoming laser installations related to inertial confinement fusion, Laser Mégajoule (LMJ) (France) and National Ignition Facility (NIF) (USA), require multidimensional numerical simulation tools for interpreting current experimental data and to perform predictive modeling for future experiments. Simulations of macroscopic plasma volumes of the order of 1 mm3 and laser exposure times of the order of hundreds of picoseconds are necessary. We present recent developments in the PARAX code towards this goal. The laser field is treated in a standard paraxial approximation in three dimensions. The plasma response is described by single-fluid, two-temperature, fully nonlinear hydrodynamical equations in the plane transverse to the laser propagation axis. The code also accounts for the dominant nonlocal transport terms in spectral form originating from a linearized solution to the Fokker–Planck equation. The simulations of interest are hohlraum plasmas in the case of indirect drive or the plasma corona for direct drive. Recent experimental results on plasma-induced smoothing of RPP laser beams are used to validate the code.

A large amplitude Trivelpiece–Gould (TG) mode, in a strongly magnetized beam–plasma system, parametrically couples to a beam space charge mode and a TG mode sideband. The density perturbation associated with the beam mode couples with the electron oscillatory velocity, due to the pump wave, to produce a nonlinear current, driving the sideband. The pump and the sideband waves exert a ponderomotive force on the electrons with a component parallel to the ambient magnetic field, driving the beam mode. For a pump wave having k0·v0b0/ω0 < 0, where ω0, k0 are the frequency and the wave number of the pump, and v0b0 is the beam velocity, the sideband is frequency upshifted. At low beam density (Compton regime) the growth rate of the parametric instability scales as two-thirds power of the pump amplitude, and one-third power of beam density. In the Raman regime, the growth rate scales as half power of beam density and linearly with pump amplitude. The background plasma has a destabilizing role on the instability.