Study of “tierras de Lebrija” by chemical, dehydration curves, d.t.a., X-ray and electron microscopic methods indicates the composition of these Pliocene sediments to be approximately equal quantities of attapulgite and illite.

La composition minéralogique de la phase <2 µm de la croûte d'altération de teinte pâele et de quelques millimétres d'épaisseur, développée sur les faces des prismes basaltiques de Roudadou, près d'Aurillac, Cantal, a été étudiée par plusieurs techniques: RX, analyse thermique différentielle, thermogravimétrie, spectroscopie infra-rouge entre 600 et 200 cm−1, mesure des surfaces totales. Cette phase fine est constituée d'une fraction non cristalline relativement réduite et surtout de minéraux argileux cristallisés, parmi lesquels l'imogolite est largement dominante (50%), accompagnée de l'halloysite (30%). Parfois une smectite compléte ce cortège argileux. A notre connaissance, l'imogolite n'avait jamais été identifiée parmi les produits d'altération superficielle des roches volcaniques du Massif Central.

The objective of this research was to study the cellulose addition effect on the geopolymerization of heated clay. The clay, composed of illite, plagioclase and kaolinite, was heated at 700°C for 2 h and mixed with cellulose (up to 10 mass%). The mixtures were NaOH-activated, and shaped samples were aged at 83°C for 30 days. The cured samples were investigated by using X-ray diffraction, Fourier-transform infrared spectroscopy and scanning electron microscopy. The influence of the cellulose addition on the mechanical/physical properties was also evaluated. The results showed that zeolite ZK-14, hydrosodalite, sodium carbonate and a geopolymer composed of poly(sialate) units were formed in all cured samples. The relative amounts of zeolite and metakaolin evolved antagonistically, whereas that of illite slightly decreased with increasing cellulose content. Metakaolin and illite were involved in the geopolymerization process. Cellulose addition led to the improvement of the flexural strength of the samples and to porosity reduction. By contrast, water absorption was increased. The positive effect of cellulose on sample performance is explained on the basis of hydrogen bonding between the functional moieties of cellulose and the active sites of sample constituents, namely zeolites, metakaolin, illite and the geopolymer. As a filler, zeolite probably contributed to sample strengthening, and the detrimental impact of Na-carbonate was insignificant. Based on the results obtained, the composites could be used as binders for brick manufacturing or as lightweight mortars.

After the last retreat of the corrie glaciers in the Ice Age the Mesozoic deposits lying at the foot of the Tertiary basalt cliffs in the Trotternish peninsula of Skye were subjected to substantial landsliding movements towards the sea. A number of lochs were held up partly by the moraines and partly by reverse slopes caused by the landslides. In a number of these lochs, after a period of partial filling by silt, diatomite has been deposited. Most of the deposits are covered with two to four feet of peat. We may roughly estimate the period of diatomite deposition to have been from about 10,000 to about 2,000 years ago. It is hoped to date the deposit accurately when samples have been examined by pollen analysis.

The surface properties of wet-ground muscovite were studied by thermodynamics of water adsorption. The surface appears to be covered by contaminating material, probably organic, which is strongly held; it was not removed at 350° C and under a vacuum of 10−4 torr. Attention is directed to the difficulty of maintaining freshly made silicate surfaces without contamination and to the importance of surface conditions in the interpretation of silicate properties which involve surface phenomena.

The catalytic cracking process, which first came into prominence during the recent war, was one of the means adopted by the petroleum industry to meet the demand for aviation spirit of high quality to fuel the Allies' air forces. It was applied mainly in the United States and quantitatively made the largest contribution of any process. The process is a modification of the older thermal cracking process, the presence of the catalyst bringing about at a lower temperature the breakdown of large hydrocarbon molecules into smaller ones (some in the petrol boiling range) whilst at the same time promoting side reactions which improve the quality of the spirit.

En el miembro basal de la Formación Utrillas, que aflora en las cercanias de Nuévalos, se ha localizado un nivel constituido por ilita, montmorillonita, natrojarosita, caolinita, cuarzo y materia carbonosa.

Se aportan datos de análisis químico, termodiferencial, termogravimetrico, microscopico y de difraccion de rayos X de la natrojarosita.

Se le atribuye a dicho sulfato un origen sedimentario por precipitación en un medio de aguas estancadas, desarrollado sobre materiales margo-yesiferos del Keuper. El hierro aportado al medio, la materia orgánica, y los iones procedentes de la disolución de las evaporitas Triasicas, provocaron las condiciones fisico-quimicas necesarias para la precipitación de la natrojarosita.

Los minerales de la arcilla son heredados, a excepcion de la montmorillonita que se la podria considerar paragenetica con la natrojarosita.

L'étude de la conductivité hydraulique sous de faibles charges de pâtes et de gels d'hectorite-Na, montre que:

• 1. La loi de Darcy peut être appliquée,

• 2. Le rayon hydraulique moyen qui est probablement relié à la distance moyenne entre les particules d'hectorite varie linéairement avec la teneur en eau et est très sensible à la présence d'électrolyte dans la suspension.

The industrial uses of clay minerals as catalysts date from the early 'thirties. The application of catalysis to the thermal cracking of oil started in about 1931; pre-heated oil was passed downwards through fixed beds of granular catalyst, often attapulgite, under pressure (80 lb. per sq. in.) and at about 900°F., as in the Houdry and Hydroforming systems. The catalyst had to be periodically burned off to regenerate it, and was reintroduced at the top of the reaction column. An improvement on this static process came when the granulated catalyst was kept moving counter current to the pre-heated oil. This led about 1939 to the fluid-flow method of catalysis in which powdered catalysts are used in a fluid, free-flowing condition, circulated by the air-rift method well-known in the movement of liquids.

The matric potential of water in gels of five-sixths neutralized aluminium montmorillonite (bentonite) and aluminium kaolinite changes during periods of shear and periods of rest. Shear increases the potential of water in bentonite gels, and in kaolinite gels containing little water, but decreases the potential in kaolinite gels containing more water. All these effects can be explained by changes in the curvature of water films at the gel-air interface. The difference between thixotropic and dilatant behaviour is the increasing and decreasing of the water potential on shearing. In dilatant pastes of silt-size particles, and for which the effects of electric charges are small, the pressure deficiency can reach large values after an increase in pore space, and this suffices to explain the characteristic features of dilatant behaviour.

Preliminary investigation of the minerals in sediment core 15 taken at a depth of 1990 metres in the Gulf of Naples shows:

1. (i) Volcanic materials, especially glass, occur throughout the core, but only in certain horizons >50%. These horizons represent periods of volcanic activities in the region and further investigation is required to correlate them.

2. (ii) No mineral in the core shows any post-depositional alteration, and most of them are clear and fresh.

3. (iii) Among the clay minerals illite is predominant, but kaolinite and mont-morillonite are also present.