Article contents
Comparison of Microwave ECR and RF Plasmas for Dry Etching of Single Crystal 6H-SiC
Published online by Cambridge University Press: 21 February 2011
Abstract
Electron cyclotron resonance (ECR) plasma etching of single crystal 6H-SiC has been investigated using a CF4/O2 gas mixture and compared to conventional reactive ion etching (RIE) in a radio frequency (13.56 MHz) reactor. The use of ECR results in higher etch rates, lower levels of bias and smoother etched surfaces than rf-RIE. ECR etch rates exceeding 100 nm/min have been obtained at a substrate bias of-100 V. Etch rate and surface morphology have been studied as a function of pressure, bias and power. Auger electron spectroscopy shows that ECR etching leaves no residues unlike rf-RIE which leaves residues containing Al, F, O and C. The current-voltage and capacitance-voltage measurements of Schottky diodes show that there is far less damage induced by ECR etching compared to rf-RIE.
- Type
- Research Article
- Information
- Copyright
- Copyright © Materials Research Society 1994
References
REFERENCES
- 8
- Cited by