The influence of flap-end geometry modifications on the near-field wake behind a generic high-lift wing/flap configuration is investigated experimentally with a single-tube yawmeter. It is found that flap-end additions tend to split the concentrated area of streamwise vorticity shed by the flap into two less intense regions, associated with the tips of the flap and the addition. For shorter additions, these regions tend to roll up together, resulting in a slightly more diffuse flap vortex of almost unchanged circulation. For larger additions, the outer region is captured by the tip vortex, which correspondingly gains in circulation at the expense of the flap vortex. In all cases, the vorticity centroid of the rolled-up wake is shifted outboard, and the overall circulation slightly increased. However, the associated lift increase implies a decrease in overall circulation at a given lift coefficient.

Aircraft handling qualities in autorotation are critical in determining the level of safety of rotorcraft. For helicopters suffering from an engine failure, transcending from powered to autorotative flight occurs rapidly and requires immediate and accurate pilot reaction. Although it is important for the handling qualities in this flight state to be predicted correctly, obvious difficulties will exist in using flight tests as a means of validation when autorotation constitutes an abnormal mode of operation. In the research work presented in this paper an alternative approach is applied, of configuring a generic rotorcraft model as a gyroplane, a type of vehicle for which its main rotor is constantly in autorotation. Flight tests are used for the validation purposes both for steady state and dynamic response cases. Results are produced to complement those already existing for a dissimilar gyroplane type thus increasing the level of confidence obtained. It is concluded that important handling qualities indicators such as the steady state trends are correctly predicted although limitations are imposed due to rotor speed discrepancy.

The present work investigates feedback control of flutter using piezoceramic strain actuators. A two degree-of-freedom oscillating airfoil model with the air loads simulated assuming unsteady aerodynamics is considered. Various feedback measurement combinations for SISO feedback control and strain actuation in the heave and pitch direction are studied to quantify their effect on flutter. The effect of sensor placement on the airfoil, for combined pitch and heave measurement feedback, is also studied. The results show that for a given aeroelastic system, sensor location is an important parameter in realizing an increase in the flutter speed. It is demonstrated that the flutter speed can be increased by more than 50% through strain actuation in the pitch direction.