Total body irradiation (TBI) is an external radiotherapy technique in which the whole body including the superficial regions is required to receive the therapeutic dose. The purpose of this study is to evaluate the received surface dose during TBI technique.

The anterior/posterior (AP/PA) TBI was implemented with 18-MV photon beam at 312-cm treatment distance for human-like phantom. The GAFCHROMIC-EBT3 films were used for superficial dose measurements.

The percentage of surface-absorbed dose relative to the prescription point for 8 points of measurements was between 102·78–121·48% and 104·51–127·43% at 5 and 10 mm depth, respectively. In the chest wall region due to the presence of lung blocks, the absorbed dose was below the acceptable level, so an electron boost was required to increase the chest wall absorbed dose.

According to the results, the implemented technique was able to deliver sufficient dose to the shallow surface of phantom’s body.

This study deals with the characteristics of simultaneous photon and electron beams in homogenous and inhomogeneous phantoms by experimental and Monte Carlo dosimetry, for therapeutic purposes. Materials and methods: Both 16 and 20 MeV high-energy electron beams were used as the original beam to strike perforated lead sheets to produce the mixed beam. The dosimetry results were achieved by measurement in an ion chamber in a water phantom and film dosimetry in a Perspex nasal phantom, and then compared with those calculated through a simulation approach. To evaluate two-dimensional dose distribution in the inhomogeneous medium, the dose–area histogram was obtained.

The highest percentage of photon contribution in mixed beam was found to be 36% for 2-mm thickness of lead layer with holes diameter of 0·2 cm for a 20 MeV primary electron energy. For small fields, the percentage depth dose parameters variations were found to be similar to pure electron beam within ±2%. The most feasible flatness in beam profile was 11% for pure electron and 7% for the mixed beam. Penumbra changes as function of depth was about ten times better than in pure electron field.

The results present some dosimetric advantages that can make this study a platform for the production of simultaneous mixed beams in future linear accelerators (LINACs), which through redesign of the LINAC head, which could lead to setup error reduction and a decrease of intra-fractional tumour cells repair.

In radiation therapy, to spare normal surrounding tissues, either Multileaf Collimators or Cerrobend blocks are used.

The current study focuses on the relative dose distribution under the areas protected by Cerrobend blocks.

A dual-energy linear accelerator and a Cobalt-60 machine were utilised as radiation sources. Several blocks were designed using commercially available materials to shield radiation fields. The relative dose distribution was then evaluated using extended dose range 2 films.

Results showed that the dose distribution under protected areas depends on several parameters including the width and height of protecting blocks, incident photon beam energy, radiation field size and source to surface distance. An increase in Cerrobend block height from 80 to 95 mm significantly decreases the dose at the protected areas.

An increase in the block width and photon energy decreases the relative dose deposition at the protected area. However, electron and neutron contaminations should also be taken into consideration.