The parameters of X-ray radiation and runaway electron beams (RAEBs) generated at long-pulse discharges in atmospheric-pressure air were investigated. In the experiments, high-voltage pulses with the rise times of 500 and 50 ns were applied to an interelectrode gap. The gap geometry provided non-uniform distribution of the electric field strength. It was founded that at the voltage pulse rise time of 500 ns and the maximum breakdown voltage Um for 1 cm-length gap, a duration [full width at half maximum (FWHM)] of a RAEB current pulse shrinks to 0.1 ns. A decrease in the breakdown voltage under conditions of a diffuse discharge leads to an increase in the FWHM duration of the electron beam current pulse up to several nanoseconds. It was shown that when the rise time of the voltage pulse is of 500 ns and the diffuse discharge occurs in the gap, the FWHM duration of the X-ray radiation pulse can reach ≈100 ns. It was established that at a pulse-periodic diffuse discharge fed by high-voltage pulses with the rise time of 50 ns, an energy of X-ray quanta and their number increase with increasing breakdown voltage. Wherein the parameter Um/pd is saved.

Discovery of soft X-ray radiation from comet Hyakutake C/1996 B2 by space telescope ROSAT in March 1996 as well as establishing the regularity of the phenomenon for comets in general opened a new area of research for the plasma astrophysics. The first soft X-ray observations have been motivated by the results of a theoretical investigation on the efficiency of production of energetic photons, in the energy range 0.1-1 keV, by hot plasma clumps generated in dusty comets via high velocity collision with interplanetary dust at small heliocentric distances. Moreover, the soft X-ray luminosities measured significantly exceeded the value predicted. A short review of proposed theoretical models and mechanisms for explaining X-ray emission from comets as well as some prospects for the future X ray observations of comets are presented.

This paper is devoted to investigations of laser energy transfer into solid targets with respect to the focusing lens focal point position relative to the solid target surface as obtained at the PALS laser facility. The third harmonic of the PALS laser beam with energy ~90 J and pulse duration ~250 ps (FWHM) was used for irradiation of two kinds of targets made of Cu: a slab and a 3.6 µm thick foil. The focal point of the beam was located either inside or in front of the target surface, and care was taken to ensure the same laser spot radii in both cases (250 µm). It was demonstrated that these two opposite focal point positions give rise to significantly different laser-plasma interactions: with either depression or maximum of the laser intensity distribution in the center of the beam, respectively. It was also verified that the focal point position inside of the target is favorable for plasma jets creation, whereas the opposite case is more effective for acceleration of flyers.