An optically transparent ultra-wideband (UWB) Vivaldi antenna with a rectifier circuit is proposed in this paper. The proposed antenna is designed and fabricated on a soda-lime glass substrate with fluorine doped conductive oxide (FTO) as the conductive layer. A radial stub is used for better impedance matching and enhancing the impedance bandwidth of the antenna. It operates over a frequency range of 2–6 GHz with a bandwidth of 4 GHz. It has a directional radiation pattern with a realized peak gain of 2.5 dBi at 4 GHz and simulated radiation efficiency greater than 28%. The transparent antenna is integrated with a rectifier and a matching circuit for radio frequency energy harvesting applications. The rectifier and matching circuit is designed on an FR4 substrate. The fabricated rectenna provided a dc voltage of 140 mV from the ambient environment. The proposed rectenna can be installed in handheld devices that increase the scope of applications in automobiles and mobile communications.

This paper presents compact rectenna arrays for ambient RF energy harvesting on the 2.45 GHz ISM band. The arrays are based on four and nine series-connected rectenna cells. Each cell is composed of a stacked fractal antenna and an RF-to-dc conversion circuit. The antenna is a compact third Koch fractal shape, fed by a coaxial probe for more compactness. The conversion circuit is a full-wave rectifier with a differential output, each DC polarity is provided by a two-stage Dickson voltage multiplier. Measurement results show a significant increase of the output DC voltage for the one, four, and nine cells rectenna arrays. They provide, for power density of 1.7 μW/cm2, an output DC voltage of 0.9, 2.2, and 4.1 Volts, respectively. The 9 cells rectenna array is used in a remote supply experiment of a temperature and acceleration wireless sensor, where the data are transmitted via a Bluetooth low energy link to a distant smartphone every 1 min.

In this paper, a 1.8–2.6 GHz wideband rectenna is designed for radio frequency (RF) energy harvesting in the context of wireless sensor nodes (WSN). To assess the feasibility of ambient RF energy harvesting, the power density from RF base stations is analyzed through statistical measurements. Power density measurements are also performed close to Wi-Fi routers. Using these results, a methodology based on impedance matching network adaptation and maximum power transfer is proposed to design the wideband RF harvester. Using this method, three RF bands, i.e. GSM1800, UMTS and WLAN, are covered. The theoretical analysis is confirmed by simulations and measurements. From measurements results, the prototype RF-to-DC conversion efficiency is 15% at −20 dBm from 1.8 to 2.6 GHz. It is shown that with three RF sources in the chosen bands, each emitting at 10 dBm, the RF-to-DC conversion efficiency is 15% better compared to that measured with a single RF source. Finally, 7 µW is harvested at 50 m from a GSM1800 and UMTS base station. This value confirms the RF harvester workability to supply small sensors.

We introduce an integrated design methodology for the optimization of RF-to-DC conversion efficiency of multi-band rectennas (rectifying antennas), with the aim of harvesting the RF energy available in humanized environments. Existing RF sources can either operate at known frequencies, power budgets, and locations, or can be ubiquitously available at different frequency bands, and with unknown directions of incidence and polarizations. In all cases, the RF link power budget may be extremely low. In order to harvest a significant quantity of energy, it is thus mandatory to place a very special care in the design of each part of the receiving/storing system. For this purpose, the receiving antenna must be optimized together with the rectifying circuit and the load. In our work, this is accomplished by a rigorous design tool based on the concurrent use of nonlinear/electromagnetic (EM) CAD tools and EM theory. The effectiveness of the method is demonstrated by comparing the computed and measured performance of single- and multi-band rectennas, both linearly and circularly polarized. Such antennas are designed to harvest RF energy from a variety of cellular and WiFi systems that are normally present in civil environments.