This paper describes the design, realization, and application of a custom temperature sensor devoted to the monitoring of the temperature differential between the leaf and the air. This difference is strictly related to the plant water stress and can be used as an input information for an intelligent and flexible irrigation system. A wireless temperature sensor network can be thought as a decision support system used to start irrigation when effectively needed by the cultivation, thus saving water, pump fuel oil, and preventing plant illness caused by over-watering.

Laboratory studies were conducted to compare the soil adsorption of aminopyralid and clopyralid with the use of batch-slurry and centrifugation assays. The calculated soil binding constants for both herbicides varied between the two techniques, but the centrifugation assay had a lower coefficient of variation compared to the batch-slurry assay. These results indicate that a centrifugation assay is a more accurate procedure for measuring the interaction of aminopyralid and clopyralid with soils. Aminopyralid adsorbed more tightly than clopyralid to six of the eight soils tested. Adsorption Kd values ranged from 0.083 to 0.364 for clopyralid and 0.106 to 0.697 for aminopyralid. Pearson correlation analysis indicated that binding of both herbicides was highly correlated to soil organic matter and texture but not to soil pH. On average, soil thin-layer chromatography indicated that aminopyralid was less mobile (Rf = 0.82) than clopyralid (Rf = 0.91), although both were mobile. These results suggest that aminopyralid will have a lower leaching potential than clopyralid. Lower potential aminopyralid soil leaching, coupled with low use rates, suggests it may be the herbicide of choice in areas where potential for leaching could be a concern.

GaN technology has gained a lot of attention in Europe over the last few years for various domains including RF electronics. After a few years of active observation, United Monolithic Semiconductors (UMS) has taken the decision to introduce a GaN technology family in its portfolio. Based on its extensive experience of III–V technology and the intensive support and collaboration with partners and European research institutes, UMS has developed the capability to produce state-of-the-art GaN devices and circuits. The present paper will summarize the current status achieved and illustrate it with a few representative examples. Aspects covering material, devices, and circuits will be addressed.

An effective linearization technique capable of equalizing IM3 products resulting from an arbitrary out-of-band blocking scenario in a wideband direct conversion receiver is presented. IM3 products are regenerated in the RF analog domain of a low-power mixed-signal feedforward path and are used to cancel analogous signal terms in the original receiver at digital baseband via adaptive equalization. The composite SAW-less receiver achieves an improvement in effective IIP3 from −7.1 to +5.3 dBm under worst-case UMTS Region 1 blocking when the feedforward path is active.