General Situation of the Basin and the Research Context
General situation of the basin
The upper reaches of the Yellow River are situated in the northeast of the Qinghai-Xizang Plateau Fig. 1. The mean elevation of the basin is over 3200 m and Maqengangrti (the highest peak) rises to 6282 m a.s.l. The study basin extends from the source of the Yellow River to Tangnag Hydrometrie Station with long axis of 1172km and area of 121,972km2. Because of relatively abundant precipitation, in the range of 300 to 750 mm a−1, low annual mean temperature between −4.0 to 1.1°C, and little evaporation, specific runoff reaches 6.5 km3 s−1 km−2 in this area, which is about three times as high as the mean value of the entire Yellow River basin. Throughout the Yellow River basin, snow and glaciers are widely distributed, with 57 glaciers around Maqengangrti peak area of 120.57 km−2. Meltwater from glaciers and snow is one of the main supply sources of spring runoff in the upper reaches of the Yellow River, accounting for about 70% of surface runoff between late March and mid-June.
The research context
The continuous monitoring of winter-spring snow cover in the area and the operational forecasting of spring runoff have been carried out using the Ice, Snow and Water Resources Information System (ISWRIS), which is a spatial data system with snow-cover information extracted from ΝΟΑΑ-9, -10 and -11, AVHRR, Landsat Thematic Mapper (TM), MSS imagery or CCT data, actual hydrometeorological data, and field investigations. The aim of the research is to provide a scientific basis for the operation and management of the Longyang Gorge reservoirs in the upper reaches of the Yellow River.
Satellite Snow-Cover Monitoring and Snow Distribution in the Basin
Information correction and data processing
(a) NOAA AVHRR data
Real-time NOAA AVHRR positive transparencies from channel I to channel IV with longitude-latitude grid are processed using a NAC-4200F Multicolour Data System as follows: first, a basin boundary is established over the 1 : 1 000 000 topographic map, and the river watershed added; channel IV (10.2 to 11.3 μm) and channel I (0.58 to 0.68 μm) images are set up successively on the screen when the images of channel I and channel II have been matched and superimposed. Second, in the procedure of density slicing, a contrast stretch is applied. Adjustment of pixel brightness is undertaken visually so that the proper brightness range of snow cover can be determined on the image. The snow-covered area is then extracted by density slicing and the graded colouring of snow-covered area. Calculation of snow-cover percentage is as follows:
where R is the snow-cover percentage of the basin; S f is the snow-cover percentage within a rectangular range, and B f is the areal percentage of the basin relative to the rectangular range.
(b) A VHRRjHRPT digital data
The preprocessing of the AVHRR/HRPT (High Resolution Picture Transmission, with about 1 km2 spatial resolution) data is carried out as follows: the CCT “IB” data set is created after correction of solar zenith angles and limb darkening; then a stereographic mosaic of AVHRR data from three orbits is used so that image distortion can be minimized. The cloud efTect can also be eliminated, by use of the “7-day minimum brightness” method according to the difference in brightness between cloud and snow and how the shape and area of cover vary with time on the image (Reference YujieLiu, 1987).
The image data file can be created through the formula below:
where G(I, J) is the minimum brightness in 7 days at the point (I, J) and gi(I, J) is the minimum brightness on a certain day (i) at the point (I, J).
The calibrated reflectance of NOAA AVHRR in the visible channel can be calculated as follows:
where R k is the reflectance of the ground surface after the correction of solar zenith angles; G is the brightness of any point on the composite image, and Si and Ii are the calibration coefficients of the visible channel.
Nine levels of brightness were separated by density slicing. The reflectance interval is 10% from level 0 to level 8, and level 9 is defined as the pixels outside the basin. Levels 0 and 1, and levels 2 and 3 represent the background and snow respectively, based on the logic analysis of season and the characteristics of the ground object. Tests show that it is reasonable that the snow data of the basin are extracted using the above interpretation criteria. The snow cover interpreted is put into the forecast model of snowmelt runoff as a variable.
(c) AVHRR/APT images
For the AVHRR/APT (Automatic Picture Transmission with resolution 4 km2) images with large distortion (provided by provincial meteorological observatories), after geometric correction, snow-covered areas are transferred from the image onto the topographic map and then measured.
(d) Snow-cover charts
A series of charts of snow cover at the scale 1 : 1 500 000 is mapped, based on AVHRR, APT images and field data on snow depth and the characteristics of snow distribution of the basin.
According to analysis of NOAA APT and AVHRR images for the fifteen years (1976–90), stable seasonal snow cover begins at the end of September or the beginning of October; the snow-covered area extends gradually from higher to lower elevations and from south to north, reaching maximum extent in the first ten days of April of the following year. Then, the area begins to contract day by day. The seasonal snow cover melts away by the first ten days of June, except in the firn basin of Anyemaqen mountain. Table 1 gives the mean value of snow-cover percentage in the study area over the years from 1976 to 1990, from the last ten days of March to the last ten days of May on the basis of APT and AVHRR data.
Main Factors Influencing Spring Runoff
(a) Relationships between snow-cover percentage and spring runoff
Analysis of AVHRR images since 1982 shows that there was abundant snow in the upper reaches of the Yellow River for the years 1982, 1983, 1989 and 1990 with correspondingly larger spring-runoff amounts. Figure 2 shows the close relationship between percentage snow cover in the basin in the last ten days of April and the mean discharge at Tangnag in the first ten days of May.
(b) Spring precipitation and air-temperature effects on runoff
Rainfall in the spring had little effect on runoff. The correlation coefficient between liquid precipitation and runofTin each month between March and June was only 0.02, 0.10, 0.31 and 0.51, respectively, for each month. Although solar radiation is the most important heat source, followed by sensible heat, air temperature can strongly influence the pattern of spring runoff.
Simulation And Forecasting Of Spring Runoff
(a) Selection of reference stations and forecasting factors
In forecasting each ten-day inflow, Y, to Longyang Gorge reservoir from the first ten days of April to the first ten days of June, principal components analysis and cognate analysis (Reference Jiyu and YinLuo and Xin, 1987) were used to select reference stations and forecasting factosrs. The following variables are used: X 2: the mean snow-cover percentage (MSCP) of the study area in October of last year (the higher the percentage of snow cover the more snow remains to contribute to spring runoff); X2: the MSCP in the ten days before issuing a forecast; X3: the mean discharge (m3s−3) at Tangnag Hydrometrie Station in the ten-day period before issuing a forecast; X4: the mean maximum temperature (°C) in October of last year at the Gulog Meteorological Observatory (GMO); X 5: precipitation (mm) in October of last year at GMO; X 5: the mean maximum temperature (°C) at GMO in the ten days before issuing a forecast; X6: the precipitation (mm) ten days before issuing a forecast at GMO. The results of the cognate analysis are listed in Table 2.
According to the needs of the Longyang Gorge reservoir, models were developed to forecast spring runoff in the upper reaches of the Yellow River using snow information from NOAA, and actual hydrometeorological data by the use of mathematical statistics, Grey system theory (Reference DengDeng, 1986) and ridge regression analysis (Reference Jiyu and YinLuo and Xin, 1987). The following formula is used for calculating the ridge regression coefficient, B(K >= 0):
where I is the unit matrix, K 0 is the ridge parameter;
is the estimated value of ridge regression coefficient. When Κ = 0, the formula above is the Ordinary Least Square Estimation (OLSE), B(K 0) can be calculated by the following formula:where i = 1, 2, . . . , p; p is the number of the predictors; λj and Sij are the characteristic value and eigenvector of
augmented matrix, respectively. The forecast value iswhere X is the predictor; B(K)0 is the ridge regression coefficient; and ε is the residual.
The ridge regression method was used for forecasting the inflow to the Longyang Gorge reservoir over ten-day periods from April to the first ten days of June. Comparisons of predicted runoff with actual measured data in 1989 and 1990 show that the forecast precision is within the permitted error range specified by the reservoir managers (within 20% of measured values).
(c) Simulation of spring runoff
Under the support of ISWRIS, the Qushian River basin, a first-order stream with its source in Anyemaqen mountain in a representative area of the upper reaches of the Yellow River, was divided into three elevation zones: zone A (below 3900 m a.s.l.), zone Β (3900 to 4650m a.s.l.) and zone C (above 4650 m a.s.l.). The snow-cover percentage in each zone was obtained from AVHRR data. The following models were established to calculate the mean discharge of the Qushian River in the period from the last ten days of March to the first ten days of June and in April:
where Q t is daily mean discharge (m3 s−1) from the last ten days of March to the first ten days of June at Damitan Hydrometrie Station on the Qushian River; k is the recession coefficient of discharge; P A is the precipitation (mm) at Golog Meteorological Station; S A is the snow-cover percentage (SCP) in zone A; P B is the precipitation (mm) at Renxiamu Meteorological Station; S B is the SCP in zone B; S C is the SCP in zone C and T c is the air temperature (°C) at Golmud Meteorological Station, all variables for the same time period.
where Q IV is the daily mean discharge (m3s−1) in April (same period for following parameters) at Damitan Hydrometrie Station; k is the recession coefficient (actual value: 0.2) of discharge; T B is the daily mean temperature (°C) at Renxiamu Meteorological Station, and the other symbols are as in Equation (7).
Table 3 shows a comparison between calculated value and measured data for the two models using the snow data separated into the three elevation zones and lumped for the entire basin. Accuracy of forecast is considerably improved by separation of snow-cover data into three elevations zones rather than by using snow cover for the entire basin.
Acknowledgements
The other persons who attended some of the field expeditions and indoor data analyses are Li Wenzhong, Zhang Shunxing, Tang Han, Liang Fengxian, Wang Guangyu, Liu Jinghuang, Pu Yibin and others. The Satellite Meteorology Centre, State Meteorological Adminstration, the Environment Forecasting Centre of National Oceanic Administration of China, the Meteorological Bureaus of Gansu and Ginghai Provinces provided meteorological data and other relative data. The Longyang Gorge water power plant gave assistance with testing and verifying of spring-runoff forecast. The assistance of the above is gratefully acknowledged.