Introduction
GaN and GaN-based heterostructures have been extensively studied due to their potential applications in the UV-blue spectral regionReference Song, Shan and Gil 1 in a wide temperature range.Reference Bidnyk, Schmidt, Cho, Gainer, Song, Keller, Mishra and DenBaars 2 - Reference Bidnyk, Little, Schmidt, Cho, Krasinski, Song, Goldenberg, Perry, Bremser and Davis 4 The success in fabrication of long lifetime cw edge-emitting laser diodes (LDs) was largely due to a significant reduction in defects attained by using laterally grown GaN on sapphire substrates.Reference Nakamura, Senoh, Nagahama, Iwasa, Yamada, Matsushita, Kiyoku, Sugimoto, Kozaki, Umemoto, Sano and Chocho 5 The selective growth of wide bandgap semiconductors is believed to be one of the most important methods to realize high performance LDs in the short wavelength region.Reference Kato, Kitamura, Hiramatsu and Sawaki 6 , Reference Kitamura, Hiramatsu and Sawaki 7 However, because of the large physical dimensions of their resonator cavities (several hundred microns), traditional edge-emitting lasers may only be used for constructing one-dimensional arrays. On the other hand, surface-emitting lasers or microstructure-based lasersReference Song, Fischer, Schmidt, Bidnyk and Shan 8 (with a typical cavity of a few microns) could potentially be used for the development of two-dimensional laser arrays. In this work we demonstrate single-mode and multi-mode room temperature (RT) laser action in two-dimensional arrays of hexagonal GaN pyramids grown on (111) Si by the selective lateral overgrowth technique. We show that the geometry of each pyramid allows the formation of a high-finesse cavity through the utilization of total internal reflection inside of the pyramids.
Experiment
Samples used in this study were grown by low-pressure metal-organic chemical vapor deposition (MOCVD). First, a 0.10-μm-thick AlN buffer layer was deposited on the Si wafer and the GaN layer was subsequently grown resulting in a thickness of about 0.15 μm. To prepare samples for selective growth, a 0.1-μm-thick Si3N4 masking layer was deposited on the wafer by plasma-enhanced chemical vapor deposition. Arrays of openings were created by photolithography and reactive ion etching. The openings were arranged in a hexagonal pattern with a 20 μm spacing and the average diameter of the openings ranged from 2 to 5 μm depending on the size of pyramids to be grown. GaN growth was then performed in the MOCVD reactor with the ammonia flow set at 1.8 slm and the triethylgallium (TEG) flow varying 1.9 to 5.3 μmol/min over the course of 3 hours at a temperature of 1050 oC. The smaller TEG flow for the initial growth was used to avoid nucleation on the mask. The growth conditions are described elsewhere9 in more detail. The result of the selective lateral overgrowth was a two-dimensional array of GaN pyramids. A scanning microscope image (SEM) image of one of the samples is shown in Fig. 1. The base diameter of the pyramids was estimated to be about 5 and 15 μm for the two different arrays of pyramids, which is considerably larger than corresponding 2 and 5 μm openings in the mask, indicating substantial lateral growth of the pyramids. Transmission electron microscope pictures revealed a drasReference Yang, McPherson, Mao, McKernan, Carter, Zheleva, Nam, Bremser and DavisRef9tic reduction in defect densities.
The samples were mounted on a translation stage that allowed 3-D positioning of the sample with ∼1 micron resolution. The third harmonic of an injection-seeded Nd:YAG laser was used as the pumping source. The pulse width of the laser was varied from 5 to 25 ns by changing the Q-switch delay. The laser beam was focused to a diameter of 4 μm through a microscope objective. The laser light intensity was attenuated continuously using a variable neutral density filter. This study was performed in a surface emitting geometry where emission from the sample was collected through the same microscope objective in the direction normal to the sample surface.
The details of the experimental configuration are described elsewhere.Reference Bidnyk, Little, Cho, Krasinski, Song, Yang and McPherson 10 This allowed us to pump, image, and spectrally analyze emission from separate pyramids.
Results and Discussion
The RT emission spectra at different pump densities (∼20-ns-pulses) near the lasing threshold for the 15-μm-wide pyramids are shown in Fig. 2. At excitation densities below the lasing threshold, only a spontaneous emission peak with a full width at half maximum (FWHM) of approximately 14 nm is present. The energy position as well as the spectral width of the peak are very similar to that observed from high-quality single-crystal GaN epilayers.Reference Yang, Schmidt, Shan, Song and Goldenberg 11 As the pump density is increased to values slightly above the lasing threshold, a very narrow peak with a FWHM of less than 0.3 nm appears on the low energy side of the spontaneous emission peak. Note that the FWHM of the stimulated emission peak in high-quality GaN epilayers is typically 2 nm at RT. The intensity of the peak shown in Fig. 2 increases superlinearly with excitation power. Both drastic narrowing of the spectra and the superlinear increase of intensity suggest that we observe single-mode laser action in the pyramids. The lasing threshold corresponds to an incident pump density of several MW/cmReference Bidnyk, Schmidt, Cho, Gainer, Song, Keller, Mishra and DenBaars 2 . However, most of the pump beam scatters off the pyramid surface. In order to estimate the coupling coefficient of the pump beam one has to consider the surface roughness and geometry of each specific pyramid.
For short excitation pulses it was also possible to observe multi-mode laser action in GaN pyramids, as shown in Fig. 3. In the case of the 15-μm wide pyramids (Fig. 3a) the average mode spacing was estimated to be 0.89 nm which corresponds to the perimeter of 58 μm for either a ring or standing-wave cavity (we assume ne = n- λ·dn/dλ = 2.65 for the effective refractive index of GaN at 370 nm, taken from Ref.[12]). For 5-μm wide pyramids (Fig. 3b) the mode spacing increased to approximately 2.2 nm which corresponds to a 23 μm in cavity perimeter. In both cases the perimeter of the cavity appears to be several times larger than the diameter of the pyramid base. This result suggests that the photon flux propagating in the cavity undergoes several (N ≥ 4) reflections inside of the pyramid prior to completing one round trip. The difference in mode spacing for the two pyramids could be explained by the difference in their physical dimensions.
To understand the geometry of the cavity formed inside of a pyramid we have to consider the limited penetration depth of the pump. We expect that the gain region can only lie in the vicinity of the surface rather than deep in the body of the pyramid. The existence of a highly modulated lasing spectrum shown in Fig. 3a with such a short gain region suggests there are very small losses associated with cavity mirror reflectivity and absorption at the lasing wavelength. For multiple reflections, only highly reflective mirrors could provide a reasonable optical feedback. Under normal incidence, a GaN-air interface reflects back approximately R = 0.2 of the incident signal. Having N near-normal reflections will result only in RN <10−3 (for N≥ 4) of the transmitted signal after one round trip in the cavity, which would require unrealistically high gain in a standing wave cavity with normally oriented end mirrors. Therefore, the cavity inside of the pyramid is most likely of a ring type formed by total internal reflections off the pyramid surfaces. This cavity could potentially lead to a large build-up of the electric field in the pyramid. The collected emission from the sample is believed to be only a scattered fraction of this field, as in the case of scattered stimulated emission observed in GaN epilayers.Reference Bidnyk, Schmidt, Park and Song 13
We further note that the pyramids used in this work are of much smaller size than conventional edge-emitting LD cavities. Even though efficient carrier injection and coupling of the emission have yet to be developed, these GaN microstructures could potentially be used as pixel elements and as high density two-dimensional laser arrays.Reference Iga, Kinoshita and Koyama 14 , Reference Koyama, Tomomatsu and Iga 15 The Si substrate used to grow the pyramids might facilitate the integration of GaN microstructures into Si-based electronics.
Conclusion
We observed single-mode and multi-mode laser action in GaN pyramids under strong optical pumping at room temperature. The pyramids were individually pumped, imaged, and spectrally analyzed through a high magnification optical system using a high density pulsed excitation source. We suggest that the cavity formed in a pyramid is of a ring type, formed by total internal reflections of light off the pyramids’ surfaces. The mode spacing of the laser emission was found to be correlated to the size of pyramids. This study suggests that GaN microstructures could potentially be used as pixel elements and high density two-dimensional laser arrays.
Acknowledgments
The authors would like to thank ONR, BMDO, NSF, and DARPA for the financial support.