Hostname: page-component-745bb68f8f-g4j75 Total loading time: 0 Render date: 2025-01-12T10:49:53.501Z Has data issue: false hasContentIssue false
  • English
  • Français

Induction machine fault diagnosis using an external radialflux sensor

Published online by Cambridge University Press:  26 October 2005

R. Romary ,
R. Corton ,
D. Thailly  and
J. F. Brudny
R. Romary*
Affiliation:
Laboratoire Systèmes Électrotechniques et Environnement, Université d'Artois, Faculté des Sciences Appliquées, Technoparc Futura, 62400 Béthune, France
R. Corton
Affiliation:
Laboratoire Systèmes Électrotechniques et Environnement, Université d'Artois, Faculté des Sciences Appliquées, Technoparc Futura, 62400 Béthune, France
D. Thailly
Affiliation:
Laboratoire Systèmes Électrotechniques et Environnement, Université d'Artois, Faculté des Sciences Appliquées, Technoparc Futura, 62400 Béthune, France
J. F. Brudny
Affiliation:
Laboratoire Systèmes Électrotechniques et Environnement, Université d'Artois, Faculté des Sciences Appliquées, Technoparc Futura, 62400 Béthune, France
*
[email protected]
Get access

Abstract

This paper presents a method for detecting faults in the induction machine using a flux sensor which measures the external radial leakage magnetic field of the machine. The procedure uses the spectral lines that correspond to the slotting effect which causes harmonics in the machine air gap. These harmonic frequencies, which are about a few kHz occur in a part of the spectra which is not very dense compared to the one that corresponds to the low frequencies due to the supply or the rotor revolution speed. The considered components can also be detected in the radial magnetic field flowing out of the machine. It can be shown that specific faults lead to additional spectral lines which appear clearly near the original ones due to the slotting effect. Two faults, which can be detected with the same magnetic flux sensor, are presented in this paper: the first one corresponds to a broken rotor bar, the second one is a stator inter turn short circuit.

Keywords

Type
Research Article
Information
The European Physical Journal - Applied Physics , Volume 32 , Issue 2 , November 2005 , pp. 125 - 132
Copyright
© EDP Sciences, 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

A. Boulenger, C. Pachaud, Surveillance des machines par analyse des vibrations (AFNOR, Paris, 1995)
H. Calis, P.J. Unsworth, Fault diagnosis in induction motors by motor current signal analysis, International Workshop SDEMPED99, Gijon, Spain, 1–3 Sept. 1999, pp. 237–241
W.T. Thomson, M. Fenger, IEEE Ind. Appl. Mag. 26 (2001)
H. Henao, T. Assaf, G.A. Capolino, Detection of voltage source dissymmetry in an induction motor using the measurement of axial leakage flux, ICEM 2000, Espoo, Finland, pp. 1110–1114
Meshgin-Kelk, H., Milimonfared, J., Toliyat, A., IEEE T. Ind. Appl. 40, 128 (2004) CrossRef
M.F. Cabanas, M.G. Melero, G.A. Orcajo, F. Rodriguez Paya, J. Solares Sariego, Experimental application of axial Leakage flux to the detection of rotor asymmetries, mechanical anomalies and interturn short circuits in working induction motors, ICEM 1998, Istanbul, Turkey, pp. 420–425
A. Henneton, D. Roger, J.F. Brudny, Electromagnetic signature of electrical machines fed by PMW inverter. MARELEC, Marine and Electromagnetic Conference and Exhibition 2001, Stockholm, Sweden, July 2001, CD ROM
A. Henneton, D. Roger, E. Napieralska, Study of electromagnetic phenomena, contribution to external radiation of machines, ICEM 2000, Finland, pp. 1125–1129
D. Thailly, R. Romary, J.F. Brudny, Diagnosis of induction Machines: Definition of Health Machine Electromagnetic Signature, 16th International Conference on Electrical Machines, ICEM 2004, Cracovia, Poland, CD ROM, paper No. 707
Y. Pankow, R. Corton, R. Romary, V. Autier, J.F. Brudny, Effets de la denture des moteurs asynchrones dans le cadre du diagnostic par mesure de champ radial in 4th international conference on Acoustical and vibratory Surveillance methods and Diagnostic Techniques, Compiègne, France, octobre 2001, pp. 283–292
Cassoret, B., Corton, R., Roger, D., Brudny, J.F., Magnetic noise reduction of induction machines, IEEE T. Power Electr. 18, 570 (2003) CrossRef
D. Belkhayat, D. Roger, J.F. Brudny, Active reduction of magnetic noise in asynchronous machine controlled by stator current harmonics, in IEE, Eighth international conference on electrical machine and drives, Cambridge, UK, Sept. 1997, pp. 400–405
J.F. Brudny, J. Phys. III France 7 (1997) 1009
B. Cassoret, M. Nabili, J.F. Brudny, Influence of rotor arrangement on induction magnetic noise, ICEM 1996, Vigo, Spain, Vol. 1, pp. 286–291
P.L. Timar, A. Fazekas, J. Kiss, A. Miklos, S.J. Yang, Noise and vibrations of electrical machine (Elsevier, 1989)
J.F. Brudny, D. Roger, Induction machine speed sensor based on stator current measurement, Sixth international conference on Power Electronics and Variable Speed Drives, IEE PEVD96, UK, 2001, pp. 283–292; 322–327
R. Fiser, S. Ferkolj, Development of steady-state mathematical model of induction motor with rotor cage fault, ICEM 1998, Istanbul, Turkey, pp. 2188–2191
Kral, C., Pirker, F., Pascoli, G., IEEE T. Ind. Appl. 38, 618 (2002) CrossRef
S.M.A. Cruz, A.J. Marques Cardoso, Rotor cage fault diagnosis in three-phase induction motors, by the synchronous reference frame current Park's Vector Approach, ICEM 2000, Espoo, Finland, pp. 779–780
S. Tnani, S. Bachir, G. Champenois, Squirrel cage modeling for broken bar detection. Diagnosis by parameter estimation, ICEM 2002, Brugge, Belgium, CD ROM, paper No. 167
Milimonfared, J., Kelk, H.M., Nandi, S., Minassians, A.D., Toliyat, H.A., IEEE T. Ind. Appl. 35, 1000 (1999) CrossRef
D.G. Dorrell, N.C. Paterson, J.F. Watson, The causes and quantification of sideband currents for use in rotor fault detection systems for cage induction motors, ICEM 1996, Vigo, Spain, Vol. 3, pp. 414–419
Elkasabgy, N.M., Eastman, A.R., Dawson, G.E., IEEE T. Ind. Appl. 28, 165 (1992) CrossRef
EPRI Research Report, Electric motor predictive and preventive maintenance guide, July 1992
Joksimovic, M.G., Penman, J., IEEE T. Ind. Electr. 47, 1078 (2000) CrossRef
Cardoso, A.J.M., Cruz, S.M.A., Fonseca, D.S.B., IEEE T. Energy Conver. 14, 595 (1999) CrossRef
S.M.A. Cruz, A.J. Marques Cardoso, Modeling and simulation of DTC induction motor drives for stator winding faults diagnosis, EPE 2003, Toulouse, France, CD ROM, paper No. 359
Stavrou, A., Seddings, H.G., Penman, J., IEEE T. Energy Conver. 16, 32 (2001) CrossRef
G. Barakat, G. Houdouin, B. Dakyo, E. Destobbeler, An accurate Method for the Study of interturn short circuits in the stator windings of induction machines, ICEM 2002, Brugge, Belgium, CD ROM, paper No. 448
Penman, J., Sedding, H.G., Lloyd, B.A., Fink, W.T., IEEE T. Energy Conver. 9, 652 (1996) CrossRef
Hénao, H., Deman, C., Capolino, G.A., IEEE T. Ind. Appl. 39, 1272 (2003) CrossRef
D. Thailly, R. Romary, J.F. Brudny, On-line detection procedure of inter-turn short circuit in induction machines, XVII-IEEE Power and Industrial Applications Summer Meeting, RVP-AI/2004, ACAPULCO, Mexique, Juillet 2004, CD ROM, SIS07.