Hostname: page-component-586b7cd67f-2brh9 Total loading time: 0 Render date: 2024-11-23T17:07:46.074Z Has data issue: false hasContentIssue false
  • English
  • Français

Surface Plasma Treatment and Sensibilization of Tin Dioxide Films for Enhancement of Gas Sensitivity and Selectivity

Published online by Cambridge University Press:  01 February 2011

Serghei V. Dmitriev ,
Vladimir I. Brinzari  and
Ghenadii S. Korotcenkov
Serghei V. Dmitriev
Affiliation:
Department of Industrial and Environmental Chemistry, Moldova State University, 60 Mateevich Str., Chisinau, MD-2009, Moldova
Vladimir I. Brinzari
Affiliation:
Department of Opto- and Microelectronics, Technical University of Moldova 168 Blv. Stefan cel Mare, Chisinau, MD-2004, Moldova
Ghenadii S. Korotcenkov
Affiliation:
Department of Industrial and Environmental Chemistry, Moldova State University, 60 Mateevich Str., Chisinau, MD-2009, Moldova
Get access

Abstract

Results of investigation aimed at the improvement of gas sensitive characteristics of tin dioxide thin film's based gas sensors through their treatment in high frequent (HF) oxygen plasma and sensibilization by means of doping are presented.

Tin dioxide thin films were deposited from alcohol solutions of SnCl45H2O by means of chemical spray pyrolysis method on alumina substrate at the temperatures in the range from 400 to 500°C. The thickness of films was varied in the range 20–100 nm.

Surface treatment of obtained tin dioxide layers was carried out in pure oxygen plasma at room temperature and 3-4 times increase of the resistance and gas sensitivity was obtained at that. These parameters' changing is discussed from the point of view of thin film's stoichiometry alteration, for control of which there were used IR and SIMS measurements. Obtained results are compared with results of the film's high temperature (∼600oC) thermal annealing on air.

To increase thin film's gas sensitivity and selectivity the doping with Pd and Cu was applied. Doping was carried out also through chemical spray pyrolysis method from the solutions of corresponding compounds of Pd and Cu. Such modification of SnO2 surface hasallowed to increasing sensitivity to H2 up to 5.103 rel. units (high selectivity) at the simultaneous shift of sensitivity maximum from 350 to 150°C. Doping with Cu has allowed to increasing 4-5 times sensitivity and selectivity toward CH4 and C3H8 gases in air and reducing operating temperatures from 500–520°C to 350–370°C.

It is concluded that combination of HF oxygen plasma tin dioxide film' treatment and its surface sensibilization is an effective way to considerably improvement of gas sensitive and selective characteristics of tin dioxide based thin film gas sensors (TFGS).

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 828: Symposium A – Semiconductor Materials for Sensing , 2004 , A5.11
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Brinzari, V., Dmitriev, S., Korotchenkov, G., Proceedings of the 9th Intern. Confer. “Transducers ′97”, Chicago, USA, June 16–19, 1997, pp.983–986 Google Scholar
2. Dmitriev, S., Brynzari, V., Korotchenkov, G.. The Second Intern. Conf. on Ecological Chemistry, Abstract Book, October 11–12, 2002, Chisinau, Republic of Moldova, p.332 Google Scholar
3. Dmitriev, S., Brinzari, V., Korotchenkov, G., The 6th Intern. Meetings on Chemical Sensors, Gaithersburg, MD, USA, July 22–25, 1996, p.268 Google Scholar