Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-25T18:45:30.054Z Has data issue: false hasContentIssue false
  • English
  • Français

Rheology Control in High Solids Solvent Borne Coatings Containing Polymer Microgels

Published online by Cambridge University Press:  15 February 2011

L. J. Boggs ,
M. Rivers  and
S. G. Bike
L. J. Boggs
Affiliation:
Department of Chemical Engineering, University of Michigan, Ann Arbor Michigan 48109-2136.
M. Rivers
Affiliation:
Department of Chemical Engineering, University of Michigan, Ann Arbor Michigan 48109-2136.
S. G. Bike
Affiliation:
Department of Chemical Engineering, University of Michigan, Ann Arbor Michigan 48109-2136.
Get access

Abstract

The focus of this work is to determine the type of interparticle forces that are primarily responsible for the rheology control of high solids solvent borne coatings containing polymer microgels. Rheological behavior is an important consideration when formulating high solids coatings due to the relatively low viscosities required for sufficient atomization during spray application and the difficulty of preventing the film from sagging during the bake cycle. Rheology control agents such as microgels are used to modify rheological properties where solvent evaporation is insufficient during the bake cycle to prevent sagging.

In this paper that describes the first phase of our work, we have characterized several microgel dispersions used as rheology control agents in high solids automotive topcoats using scanning electron microscopy (SEM) and steady shear viscosity measurements. The steady shear viscosity versus microgel volume fraction data was compared with the expected behavior of ideal hard sphere dispersions. One of the microgel dispersions showed very nearly ideal behavior while others deviated from the expected behavior at higher volume fractions. We have also investigated the steady shear behavior of increasing concentrations of microgel dispersions added to low molecular weight acrylic polymer, typical of resins used in high solids automotive coatings. These microgel dispersions induce a yield stress in the Newtonian resin that shows a strong dependence on microgel particle concentration.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 289: Symposium M – Flow and Microstructure of Dense Suspensions , 1992 , 221
Copyright
Copyright © Materials Research Society 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] Bauer, D.R., Briggs, L.M., and Dickie, R.A., Ind. Eng. Chem. Prod. Res. Dev., 21, 686 (1982).Google Scholar
[2] Smith, A., Reichert, W.W., and Nae, H., J. Coatings Tech., 62(784), 45 (1990).Google Scholar
[3] Ellis, W.H., J.Coatings Tech., 55(696), 63 (1983).Google Scholar
[4] Otsubo, Y., Amari, T., and Watanabe, K., T. Rheology, 31(3), 251 (1987).Google Scholar
[5] Funke, W.E., J. Coatings Tech., 60(767), 69 (1988).Google Scholar
[6] Ketz, R.J. Jr.,, Prud'home, R.K., and Graessley, W.W., Rheologica Acta, 27, 531 (1988).Google Scholar
[7] Wolfe, M.S. and Scopazzi, C., J. Colloid Interface Sci. 133(1), 265 (1989).Google Scholar
[8] Antonietti, M. and Bremser, W., Macromolecules, 23, 3796 (1990).Google Scholar
[9] Wu, S., J. Applied Polymer Sci., 22, 2769 (1978).Google Scholar
[10] Wu, S., J. Applied Polymer Sci., 22, 2783 (1978).Google Scholar
[11] lshii, K., Ishikura, S., and Mizuguchi, R., FATIPEC Congress IV, 187 (1988).Google Scholar
[12] Ishikura, S., Ishii, K., and Mizuguchi, R., Prog. Organic Coatings, 15, 373 (1988).Google Scholar
[13] Bauer, D.R., Organic Coatings, 7, 157 (1984).Google Scholar
[14] Bauer, D.R., J. Colloid Interface Sci., 94(2), 584 (1983).Google Scholar
[15] Hill, L.W. and Kozlowski, K., J. Coatings Tech., 59(751), 63 (1987).Google Scholar
[16] Krieger, I.M. and Dougherty, T.J., Trans. Soc. Rheology, 3, 137 (1959).Google Scholar
[17] Jones, D.A.R., Leary, B., and Boger, D.V., J. Colloid Interface Sci., 147(2), 479 (1991).Google Scholar
[18] Casson, N. in Rheology of Disperse Systems, ed. Mill, C.C. (Pergamon Press, New York, 1959), pp. 84–104.Google Scholar