Hostname: page-component-586b7cd67f-2plfb Total loading time: 0 Render date: 2024-11-25T17:36:02.595Z Has data issue: false hasContentIssue false
  • English
  • Français

Damage Evolution in Xe-Ion Irradiated Rutile (TiO2) Single Crystals

Published online by Cambridge University Press:  15 February 2011

Fuxin Li ,
Ping Lu ,
Kurt E. Sickafus ,
Caleb R. Evans  and
Michael Nastasi
Fuxin Li
Affiliation:
New Mexico Institute of Mining and Technology, Socorro, NM 87801. Materials Science & Technology Division, Los Alamos National Laboratory, Los Alamos, NM 87545
Ping Lu
Affiliation:
New Mexico Institute of Mining and Technology, Socorro, NM 87801.
Kurt E. Sickafus
Affiliation:
Materials Science & Technology Division, Los Alamos National Laboratory, Los Alamos, NM 87545
Caleb R. Evans
Affiliation:
Materials Science & Technology Division, Los Alamos National Laboratory, Los Alamos, NM 87545
Michael Nastasi
Affiliation:
Materials Science & Technology Division, Los Alamos National Laboratory, Los Alamos, NM 87545
Get access

Abstract

Rutile (TiO2) single crystals with (110) orientation were irradiated with 360 keV Xe2+ ions at 300K to fluences ranging from 2×1019 to 1×1020 Xe/m2. Irradiated samples were analyzed using: (1) Rutherford backscattering spectroscopy combined with ion channeling analysis (RBS/C); and (2) cross-sectional transmission electron microscopy (XTEM). Upon irradiation to a fluence of 2×1O19 Xe/m2, the sample thickness penetrated by the implanted ions was observed to consist of three distinct layers: (1) a defect-free layer at the surface (thickness about 12 nm) exhibiting good crystallinity; (2) a second layer with a low density of relatively large- sized defects; and (3) a third layer consisting of a high concentration of small defects. After the fluence was increased to 7×1019 Xe/m2, a buried amorphous layer was visible by XTEM. The thickness of the amorphous layer was found to increase with increasing Xe ion fluence. The location of this buried amorphous layer was found to coincide with the measured peak in the Xe concentration (measured by RBS/C), rather than with the theoretical maXimum in the displacement damage profile. This observation suggests the implanted Xe ions may serve as nucleation sites for the amorphization transformation. The total thickness of the damaged microstructure due to ion irradiation was always found to be much greater than the projected range of the Xe ions. This is likely due to point defect migration under the high stresses induced by ion implantation.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 540: Symposium N / Microstructural Processes in Irradiated Materials , 1998 , 311
Copyright
Copyright © Materials Research Society 1999

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] Khubeis, I., Fromknecht, R., and Meyer, O., Phys. Rev. B 55 (1997) 1.Google Scholar
[2] Khubeis, I. and Meyer, O., Nucl. Instr. and Meth. and Phys. Res. B120 (1996) 257.Google Scholar
[3] Meyer, O., Khubeis, I., Fromknecht, R. and Massing, S., Nucl. Instr. and Meth. and Phys. Res. B136/138 (1998) 436.Google Scholar
[4] Meyer, O., Khubeis, I., Fromknecht, R. and Massing, S., Nucl. Instr. and Meth. and Phys. Res. B127/128 (1997) 624.Google Scholar
[5] Fromknecht, R., Auer, R., Khubeis, I. and Meyer, O., Nucl. Instr. and Meth. and Phys. Res. B120 (1996) 252.Google Scholar
[6] Fromknecht, R. and Meyer, O., Mater. Chem. Phys., 45 (1996) 50.Google Scholar
[7] Hartmann, T., Wang, L. M., Weber, W. J., Yu, N., Sickafus, K. E., Mitchell, J. N., Wetteland, C. J., Nastasi, M. A., Hollander, M. G., Baker, N. P., Evans, C. R., Tesmer, J. R., and Maggiore, C. J., Nucl. Instr. and Meth. in Phys Res. B141 (1998) 398.Google Scholar
[8] Ziegler, J. F., Biersack, J. P.., Littmark, U., The Stopping and Range of Ions in Solids, Pergamon, New York, 1985.Google Scholar
[9] Doolittle, L. R., Nucl. Instr. and Meth. B9 (1985) 344.Google Scholar
[10] Doolittle, L. R., Nucl. Instr. and Meth. B15 (1986) 227.Google Scholar
[11] Arnold, G. W., Nucl. Instr. and Meth. in Phys. Res. B65 (1992) 213.Google Scholar
[12] Gong, W. L., Wang, L. M., and Ewing, R. C., J. Appl. Phys. 84(8) (1998) 4204.Google Scholar
[13] Arnold, G. W., Battaglin, G., Boscolo-Boscoletto, A., Cacavale, F., Marchi, G. De, Mazzodli, P. and Miotello, A., Nucl. Instr. and Meth. in Phys. Res. B65 (1992) 387.Google Scholar
[14] Fayeulle, S. and Nastasi, M., Appl. Phys. Lett. 73(8) (1998) 1077.Google Scholar