Hostname: page-component-586b7cd67f-dsjbd Total loading time: 0 Render date: 2024-11-25T17:39:13.699Z Has data issue: false hasContentIssue false
  • English
  • Français

A Quantitative Model for Interpreting Nanometer Scale Hardness Measurements of Thin Films

Published online by Cambridge University Press:  15 February 2011

W.H. Poisl ,
B.D. Fabes  and
W.C. Oliver
W.H. Poisl
Affiliation:
Dept. of Materials Science and Engineering, University of Arizona, Tucson, AZ 85721.
B.D. Fabes
Affiliation:
Dept. of Materials Science and Engineering, University of Arizona, Tucson, AZ 85721.
W.C. Oliver
Affiliation:
Metals and Ceramics Division, Oak Ridge National Laboratories, Oak Ridge, TN, 37831.
Get access

Abstract

A model has been developed to determine the hardness of thin films from the measured change in hardness with indenter displacement using a depth-sensing indentation instrument. The model is developed by dividing the measured hardness into film and substrate contributions based on the projected areas of both the film and substrate under the indenter. The model incorporates constraints on the deformation of the film by the surrounding material in the film, the substrate, and friction at the indenter/film and film/substrate interfaces. These constraints increase the pressure that the film can withstand and account for the increase in measured hardness as the indenter approaches the substrate.

The model is evaluated by fitting the predicted hardness versus depth curves to data obtained from titanium and Ta2O5 films of varying thicknesses on sapphire substrates. The model predicts a lower interfacial strength for Ta2O5 films on sapphire with a carbon layer between the film and the substrate than that obtained for a film without an interfacial carbon layer.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 308: Symposium M1 – Thin Films: Stresses and Mechanical Properties IV , 1993 , 201
Copyright
Copyright © Materials Research Society 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1 Bhattacharya, A.K. and Nix, W.D., International Journal of Solids and Structures, 24 [12], 1287–1298 (1988).Google Scholar
2 Sargent, P.M., in Microindentation Techniques in Materials Science and Engineering, edited by Blau, P.J. and Lawn, B.R. (American Society of Testing and Materials, Philadelphia, PA, 1986).Google Scholar
3 Burnett, P.J. and Rickerby, D.S., Thin Solid Films, 148, 41–50 (1987).Google Scholar
4 Fabes, B.D., Oliver, W.C., McKee, R.A. and Walker, F.J., Journal of Materials Research, 7 [11], 3056–3064 (1992).Google Scholar
5 Jonnson, B. and Hogmark, S., Thin Solid Films, 114, 257–269 (1984).Google Scholar
6 Stone, D., LaFontaine, W., Alexopoulous, P., Wu, T. and Li, C., Journal of Materials Research, 3 [1], 141–147 (1988).Google Scholar
7 Dieter, G.E., Mechanized Metallurgy (McGraw-Hill, New York, 1986), 3rd edition.Google Scholar
8 Engel, P.A. and Roshon, D.D., Journal of Adhesion, 10, 237–253 (1979).Google Scholar