Hostname: page-component-586b7cd67f-rdxmf Total loading time: 0 Render date: 2024-11-29T07:34:52.031Z Has data issue: false hasContentIssue false

Importance of Defect Density near the p-i Interface for a-Si:H Solar Cell Performance

Published online by Cambridge University Press:  17 March 2011

C. Smit
Affiliation:
Delft University of Technology, DIMES, Feldmannweg 17, 2628 CT DELFT, The Netherlands Eindhoven University of Technology, Department of Applied Physics, P.O. Box 513, 5600 MB EINDHOVEN, The Netherlands
R.A.C.M.M. van Swaaij
Affiliation:
Delft University of Technology, DIMES, Feldmannweg 17, 2628 CT DELFT, The Netherlands
D.C. Schram
Affiliation:
Eindhoven University of Technology, Department of Applied Physics, P.O. Box 513, 5600 MB EINDHOVEN, The Netherlands
M.C.M. van de Sanden
Affiliation:
Eindhoven University of Technology, Department of Applied Physics, P.O. Box 513, 5600 MB EINDHOVEN, The [email protected]
Get access

Abstract

A cascaded arc expanding thermal plasma is used to deposit intrinsic hydrogenated amorphous silicon at growth rates larger than 2 Å/s. Implementation into a single junction p-i-n solar cell resulted in initial efficiencies of ∼7%, although all the optical and initial electrical properties of the individual layers are comparable with RF-PECVD deposited films. The somewhat lower efficiency is due to a smaller fill factor. Spectral response measurements, illuminated J,V- measurements, and simulations indicate that a higher local defect density in the region near the p-i interface might be responsible for the smaller fill factor in comparison with conventional low- rate RF-PECVD. The higher defect density is most likely caused by the initial growth in the first 10 to 50 nm. Therefore, controlled initial growth of the intrinsic layer is suggested for good solar cell performance.

Type
Research Article
Copyright
Copyright © Materials Research Society 2001

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Korevaar, B.A., Adriaenssens, G.J., Smets, A.H.M., Kessels, W.M.M., Song, H.-Z., Sanden, M.C.M. van de, and Schram, D.C., J. Non-Cryst. Sol., 266–269 (2000) 380 Google Scholar
2. Korevaar, B.A., Smit, C., Smets, A.H.M., Swaaij, R.A.C.M.M. van, Schram, D.C., and Sanden, M.C.M. van de, Proc. of 28th IEEE-PVSC (2000)Google Scholar
3. Smets, A.H.M., et al., to be published (2001)Google Scholar
4. Zeman, M., Tao, G., Trijssenaar, M., Willemen, J.W., Metselaar, J.W., and Schropp, R.E.I., Mat. Res. Soc. Symp. Proc., 377 (1995) 639 10.1557/PROC-377-639Google Scholar
5. Kessels, W.M.M., Sanden, M.C.M. van de, and Schram, D.C., J. Vac. Sci. Techn. A, 81 (2000) 2153 Google Scholar
6. Severens, R.J., Brussaard, G.J.H., Sanden, M.C.M. van de, and Schram, D.C., Appl. Phys. Lett., 67 (1995) 491 Google Scholar
7. Sanden, M.C.M. van de, Regt, J.M. de, and Schram, D.C., Plasma Sources Sci. Technol., 3 (1994) 501 Google Scholar
8. Jackson, W.B., Biegelsen, D.K., Nemanich, R.J., and Knights, J.C., Appl. Phys. Lett., 42 (1983) 105 Google Scholar
9. Fortmann, C.M., Physical Review Letters, 81 (1998) 3683 10.1103/PhysRevLett.81.3683Google Scholar
10. Smets, A.H.M., Schram, D.C., and Sanden, M.C.M van de, Mat. Res. Soc. Symp. Proc., 609 (2000) A7.6.1 Google Scholar
11. Smets, A.H.M., Helden, J.H. van, and Sanden, M.C.M. van de, Mat. Res. Soc. Symp. Proc., 664 (2001) A22.4.1 10.1557/PROC-664-A22.4Google Scholar
12. Koh, J., Lee, Y., Fujiwara, H., Wronski, C.R., and Collins, R.W., Appl. Phys. Lett., 73 (1998) 1526 10.1063/1.122194Google Scholar
13. Pearce, J.M., Koval, R.J., Ferlauto, A.S., Collins, R.W., Wronski, C.R., Yang, J., and Guha, S., Appl. Phys. Lett., 77 (2000) 3093 Google Scholar
14. Gunes, M. and Wronski, C.R., J. Appl. Phys., 81 (1997) 3526 Google Scholar
15. Wang, Q., Iwaniczko, E., Xu, Y., Nelson, B.P., Mahan, A.H., Crandall, R.S., and Branz, H.M., Proc. of 28th IEEE-PVSC (2000)Google Scholar
16. Kroon, M.A. and Swaaij, R.A.C.M.M. van, to be published in J. Appl. Phys. (2001)Google Scholar