Hostname: page-component-586b7cd67f-vdxz6 Total loading time: 0 Render date: 2024-11-25T17:34:37.158Z Has data issue: false hasContentIssue false
  • English
  • Français

Degradation of Amorphous Silicon Based Photoconductors by Corona Discharge

Published online by Cambridge University Press:  01 January 1993

R.A.C.M.M.VAN Swaaij ,
W.P.M. Willems ,
J. Bezemer ,
H.J.P. Lokker  and
W.F. Van Der Weg
R.A.C.M.M.VAN Swaaij
Affiliation:
Department of Atomic and Interface Physics,, Debye Institute,Utrecht University,P. O. Box 80.000, NL-3508 TA Utrecht, The Netherlands
W.P.M. Willems
Affiliation:
Stork Colorproofing B.V., P.O. Box 210, NL-5830 AE Boxmeer, The Netherlands
J. Bezemer
Affiliation:
Department of Atomic and Interface Physics,, Debye Institute,Utrecht University,P. O. Box 80.000, NL-3508 TA Utrecht, The Netherlands
H.J.P. Lokker
Affiliation:
Department of Atomic and Interface Physics,, Debye Institute,Utrecht University,P. O. Box 80.000, NL-3508 TA Utrecht, The Netherlands
W.F. Van Der Weg
Affiliation:
Department of Atomic and Interface Physics,, Debye Institute,Utrecht University,P. O. Box 80.000, NL-3508 TA Utrecht, The Netherlands
Get access

Abstract

Thin three-layered a-Si:H photoconductive structures have been studied for application in high resolution electrophotography. The resolution of prints is determined by the a-Si:C:H top layer. It is observed that the resolution of prints decreases from 100 to 30 lines/mm after about 25 charge cycles of corona discharge. The effect of corona charging on the surface properties of a-Si:C:H films with different carbon content is studied. Before and after corona exposure Fourier transform infrared absorption and lateral dark conductivity were measured. We observe that modes around 3300 cm-1, ascribed to H2O and -OH related modes, arise in combination with an increase of the lateral dark conductivity. This effect is not dependent on the film thickness, indicating that only the surface is affected by the corona discharge. The increase of the dark conductivity is interpreted as due to band bending at the surface, induced by the adsorption of H2O or the growth of a thin Si-OH layer at the surface.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 297: Symposium A – Amorphous Silicon Technology - 1993 , 1993 , 559
Copyright
Copyright © Materials Research Society 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Schaffert, R., Electrophotography (Focal Press, 1975), p. 397.Google Scholar
2. Paasche, S. M. and Bauer, G. H. in Materials Issues in Amorphous Semiconductor Technology, edited by Adler, D., Hamakawa, Y. and Madan, A. (Mat. Res. Soc. Symp. Proc. 70, Pittsburgh, PA, 1986), pp. 671–677.Google Scholar
3. Herremans, H., Grevendonk, W., van Swaaij, R. A. C. M. M., van Sark, W. G. J. H. M., Berntsen, A. J. M., Arnold Bik, W. B. and Bezemer, J., Philos. Mag. B, 66, 787 (1992).Google Scholar
4. Kodama, J., Araki, S., Kimura, M. and Inagaki, T., Jpn. J. Appl. Phys., 29, L867 (1990).Google Scholar
5. Tanielian, M., Philos. Mag. B, 45, 453 (1982).Google Scholar