Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-26T06:29:11.689Z Has data issue: false hasContentIssue false
  • English
  • Français

The Effect of Focused Ion Beam (Fib) Specimen Geometry on X-Ray Fluorescence During Energy Dispersive X-Ray Spectroscopy (EDS) Analysis in the Transmission Electron Microscope (TEM)

Published online by Cambridge University Press:  02 July 2020

David M. Longo ,
James M. Howe  and
William C. Johnson
David M. Longo
Affiliation:
Department of Materials Science and Engineering, University of Virginia, Charlottesville, VA22903
James M. Howe
Affiliation:
Department of Materials Science and Engineering, University of Virginia, Charlottesville, VA22903
William C. Johnson
Affiliation:
Department of Materials Science and Engineering, University of Virginia, Charlottesville, VA22903
Get access

Extract

The focused ion beam (FIB) has become an indispensable tool for a variety of applications in materials science, including that of specimen preparation for the transmission electron microscope (TEM). Several FIB specimen preparation techniques have been developed, but some problems result when FIB specimens are analyzed in the TEM. One of these is X-ray fluorescence from bulk material surrounding the thin membrane in FIB-prepared samples. This paper reports on a new FIB specimen preparation method which was devised for the reduction of X-ray fluorescence during energy dispersive X-ray spectroscopy (EDS) in the TEM.

Figure 1 shows three membrane geometries that were investigated in this study on a single-crystal Si substrate with a RF sputter-deposited 50 nm Ni film. Membrane 1 is the most commonly reported geometry in the literature, with an approximately 20 urn wide trench and a membrane having a single wedge with a 1.5° incline.

Type
Specimen Preparation
Information
Microscopy and Microanalysis , Volume 4 , Issue S2: Proceedings: Microscopy & Microanalysis '98, Microscopy Society of America 56th Annual Meeting, Microbeam Analysis Society 32nd Annual Meeting, Atlanta, Georgia July 12-16, 1998 , July 1998 , pp. 856 - 857
Copyright
Copyright © Microscopy Society of America

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1.Stevie, F.A., et al., Surface and Interface Analysis, 23 (1995) 61.CrossRefGoogle Scholar
2.Leslie, A.J., et al., ISTFA Symposium (1995) 353.Google Scholar
3.Young, R.J., et al., Mat. Res. Symp. Proa, 199 (1990) 205.CrossRefGoogle Scholar
4. This research was supported by the National Science Foundation under grant DMR-9496133.Google Scholar