Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-26T06:24:53.719Z Has data issue: false hasContentIssue false

Assessment of Deformation using the Focused Ion Beam Technique

Published online by Cambridge University Press:  02 July 2020

M.G. Burke
Affiliation:
Bechtel Bettis, Inc., West Mifflin, PA, 15122, USA
P.T. Duda
Affiliation:
Bechtel Bettis, Inc., West Mifflin, PA, 15122, USA
G. Botton
Affiliation:
CANMET, 567 Booth St., Ottawa, Ontario, Canada
M. W. Phaneuf
Affiliation:
Fibics, Inc., 567 Booth St., Ottawa, Ontario, Canada
Get access

Extract

Focused Ion Beam (FIB) micromachining techniques have gained significant attention over the past few years as a promising method for the preparation of a variety of metallic and nonmetallic materials for subsequent characterization using transmission electron microscopy (TEM) The advantage of the FIB in terms of site specificity and speed for the preparation of uniform electron transparent sections has opened a wide range of potential applications in materials characterization. The ability to image the sample in the FIB can also provide important microstructural data for materials analysis. In this study, both conventionally electropolished and FIB-ed specimens were prepared in order to characterize the microstructure of a commercially-produced tube of Alloy 600 (approximately Ni-15 Cr-10 Fe- 0.05 C). The electropolished samples were prepared using a solution of 20% HClO4 - 80% CH3OH at ∼-40°C. The FIB sections were obtained from a cross-section of the tube that had been mechanically thinned to ∼100 μm. The section was thinned in a Micrion 2500 FIB system with a Ga ion beam at 50 kV accelerating voltage.

Type
Applications and Developments of Focused Ion Beams
Copyright
Copyright © Microscopy Society of America

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

References:

1.Phaneuf, M. W., Micron, 30(1999) 247.Google Scholar
2.Evans, R. D., Phaneuf, M. W. and Boyd, J. D., J. Microscopy, 196 (1999) 146.CrossRefGoogle Scholar
3.Lo, J., Li, J., Myrayama, T. and Phaneuf, M. W., Proc. 2nd Joint Canada-Japan Workshop on Composites (Technomic Publishing Co., Lancaster, PA) 1998, 41.Google Scholar
4.Larson, D. J. et al., Nanotechnology, 10 (1999) 45.CrossRefGoogle Scholar