Hostname: page-component-586b7cd67f-2plfb Total loading time: 0 Render date: 2024-11-27T04:45:11.433Z Has data issue: false hasContentIssue false

Relationship Between High-Strain-Rate Superplasticity and Interface Microstructure in Aluminum Alloy Composites

Published online by Cambridge University Press:  02 July 2020

J. Koike
Affiliation:
Dept. of Materials Science, Tohoku University, Sendai, 980-8579, Japan
K.E. Sickafus
Affiliation:
Materials Science and Technology Division, Los Alamos National Laboratory
T.E. Mitchell
Affiliation:
Center for Materials Science, Los Alamos National Laboratory, Los Alamos, NM87535
Get access

Extract

The Al alloy composites reinforced with Si3N4 or SiC have been reported to exhibit superplasticity at high strain rate of faster than 1x10−2 s−1. It has been shown in many aluminum alloy composites that the optimum superplastic temperature coincides with an incipient melting temperature. The coincidence suggests a contribution of the liquid phase to the superplasticity mechanism. This paper shows a direct evidence of partial melting along matrix grain boundaries and matrix-reinforcement interfaces. Based on the obtained results, the role of the liquid phase in the high-strain-rate superplasticity is discussed.

The sample was Al-Mg (5052) alloy reinforced with 20vol% Si3,N4 particles, fabricated by a powder metallurgy process. The sample showed an excellent superplasticity under the conditions given in Table 1. Partial melting was confirmed to occur at 821 K by differentail scanning calorimetry. The microstructural changes during heating were observed in situ by TEM using a heating stage. The structure of interfaces and grain boundaries was observed by HREM. Chemical analysis was performed with EDS attached to VG-STEM.

Type
Future of Microscopy: Ceramics, Composites, and Cement
Copyright
Copyright © Microscopy Society of America

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

This research was supported by the US DOE, OBES and by Japanese Ministry of Education.