Article contents
Microstructure and Microchemistry of Y-Doped a-Al203
Published online by Cambridge University Press: 02 July 2020
Extract
A thorough microstructural study of common ceramics requires analysis at various length scales. Yttrium doped, polycrystalline α-Al203 was studied using a broad selection of microscopy techniques over a scale range covering seven-orders of magnitude (i.e. from mm to Å).
Yttrium doped, (1000 (Y/Al) atomic ppm) polycrystalline alumina samples were prepared by hot pressing at 1450°C at 50 MPa. Some were subsequently crept in tension. Microstructure of these samples was studied by optical microscopy, scanning electron/orientation imaging microscopy (OIM™), conventional and high resolution transmission electron microscopy. Analytical electron microscopy was performed on a VG HB501 FEG-STEM equipped with an EDS and PEELS.
On a large scale, the microstructure often consisted of bimodal sized alumina grains and second phase YAG (Y3A15012) precipitates. YAG precipitates at grain boundaries (GB) and triple points caused clusters (50μm to 1mm) of small equi-axed alumina grains (0.5-2 μm) randomly distributed over 40 area% of the sample.
- Type
- Microscopy of Ceramics and Minerals
- Information
- Copyright
- Copyright © Microscopy Society of America
References
(1) Cho, J. et al., J. Am. Ceram. Soc. 80, 1013–1017 (1997).CrossRefGoogle Scholar
(2) Authors gratefully acknowledge Harmer, M. P. for supplying the samples.Google Scholar
(3) Mulvihill, M.L. is supported by Humboldt, A. V. Research Fellowship.Google Scholar
- 1
- Cited by