Hostname: page-component-586b7cd67f-dlnhk Total loading time: 0 Render date: 2024-11-27T06:33:46.141Z Has data issue: false hasContentIssue false

In-Situ HREM of A Surface Reconstruction of Si Surface With Molten Al at High Temperatures

Published online by Cambridge University Press:  02 July 2020

S. Tsukimoto
Affiliation:
Department of Quantum Engineering, Nagoya University, Nagoya, 464-8603, Japan
S. Arai
Affiliation:
Center for Integrated Research in Science and Engineering, Nagoya, 464-8603, Japan
H. Miyai
Affiliation:
Department of Quantum Engineering, Nagoya University, Nagoya, 464-8603, Japan
H. Saka
Affiliation:
Department of Quantum Engineering, Nagoya University, Nagoya, 464-8603, Japan
Get access

Extract

Introduction

The morphology of Si surface has much effect on physical and chemical properties of the surface. It is well known that the structure of Si surface can be modified by deposition of metals, and extensive studies have been carried out on the modified surface structures of Si. These studies were carried out on clean surfaces of Si in an ultra-high vacuum (UHV). However recently, it has been shown by Kamino et al.[l] that molten Au atoms remove a surface amorphous layer on the Si surface, making the surface clean even in a non ultra-high vacuum. The present study is an extension to the previous one (Kamino et al.) and Si surfaces modified by-molten Al atoms in a conventional vacuum were observed by means of TEM.

Experimental

The specimen used in this study was a mixture of pure Al particles and Si particles, the latter being prepared by crushing a Si single crystal into pieces.

Type
A. Howie Symposium: Celebration of Pioneering Electron Microscopy
Copyright
Copyright © Microscopy Society of America

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1.Kamino, T, Yaguchi, M., Tomita, M., and Saka, H, Phil. Mag. A., 75(1997)105.CrossRefGoogle Scholar
2.Kamino, T, and Saka, H., Microsc. Microanal. Microstruct., 4(1993)127.CrossRefGoogle Scholar
3.Howe, J.M., 1993, Interface in Materials, John-Wiley & Sons, Inc., New YorkGoogle Scholar