Hostname: page-component-78c5997874-j824f Total loading time: 0 Render date: 2024-11-20T04:03:52.792Z Has data issue: false hasContentIssue false
  • English
  • Français

SiC whisker- and C fiber-reinforced calcium phosphate composites

Published online by Cambridge University Press:  03 March 2011

K. Hark ,
S. Sundaresan ,
T. Vasilos  and
C. Sung
K. Hark
Affiliation:
Center for Advanced Materials and Department of Chemical Engineering, University of Massachusetts, Lowell, Massachusetts 01854
S. Sundaresan
Affiliation:
Center for Advanced Materials and Department of Chemical Engineering, University of Massachusetts, Lowell, Massachusetts 01854
T. Vasilos
Affiliation:
Center for Advanced Materials and Department of Chemical Engineering, University of Massachusetts, Lowell, Massachusetts 01854
C. Sung
Affiliation:
Center for Advanced Materials and Department of Chemical Engineering, University of Massachusetts, Lowell, Massachusetts 01854
Get access

Abstract

SiC whisker/calcium phosphate and C fiber/calcium phosphate composites were fabricated by hot-pressing at 1185 °C and 7.6 MPa in vacuum. The microstructural characteristics, especially interfaces, of these composites were studied using transmission electron microscopy. The mechanical properties of these composites were measured by four-point bending tests. It was found that the mechanical properties of these calcium phosphate-based composites were strongly dependent on their microstructural characteristics.

Type
Rapid Communications
Information
Journal of Materials Research , Volume 9 , Issue 10 , October 1994 , pp. 2476 - 2479
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1Lavernia, C. and Schoenung, J. M., Am. Ceram. Soc. Bull. 70, 95 (1991).Google Scholar
2Doyle, C., Handbook of Bioactive Ceramics Vol. II, edited by Yamamuro, T., Hench, L. L., and Wilson, J. (CRC Press, Boca Raton, FL, 1990).Google Scholar
3ASTM C 373, ASTM, Philadelphia, PA (1993).Google Scholar
4ASTM D 790, ASTM, Philadelphia, PA (1993).Google Scholar
5Makisalo, S. E., Paavolainen, P., Gronblad, M., and Holmstrom, T., Biomaterials 10, 105 (1989).CrossRefGoogle Scholar