Hostname: page-component-78c5997874-8bhkd Total loading time: 0 Render date: 2024-11-05T08:37:51.679Z Has data issue: false hasContentIssue false

Fabrication, Structural, and Spectroscopic Investigation of Tb-Doped Lu3Al5O12 Phosphor

Published online by Cambridge University Press:  03 March 2011

Yikun Liao
Affiliation:
State Key Laboratory of High Performance Ceramics and Superfine Microstructures, Shanghai Institute of Ceramics, Chinese Academy of Sciences, Shanghai 200050, People’s Republic of China
Danyu Jiang
Affiliation:
State Key Laboratory of High Performance Ceramics and Superfine Microstructures, Shanghai Institute of Ceramics, Chinese Academy of Sciences, Shanghai 200050, People’s Republic of China
Tao Feng
Affiliation:
State Key Laboratory of High Performance Ceramics and Superfine Microstructures, Shanghai Institute of Ceramics, Chinese Academy of Sciences, Shanghai 200050, People’s Republic of China
Jianlin Shi
Affiliation:
State Key Laboratory of High Performance Ceramics and Superfine Microstructures, Shanghai Institute of Ceramics, Chinese Academy of Sciences, Shanghai 200050, People’s Republic of China
Get access

Abstract

A simple solution combustion synthesis technique was explored to produce Tb3+-doped Lu3Al5O12 (LuAG:Tb) phosphor with particle size in the range from about 25 to 900 nm by using glycine, urea, and the mixture of them as fuels. The effects of processing parameters such as type of fuel, fuel-to-oxidizer ratio and the composition of the complex fuel were studied. An increase in phosphor brightness and a decrease in crystallization temperature with increasing urea content in the fuel were observed. The integrated emission intensity ratio of the 5D37Fj transition to the 5D47Fj transition as a function of Tb concentration in LuAG was also investigated. It is very interesting that the growth process of the particles exhibited two steps when the content of urea in the complex fuel increased from 0 to 1.0. By tailoring the glycine-to-urea ratio in the fuel, an excellent fuel was found and high performance phosphors were obtained.

Type
Articles
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1van Eijk, W.E. Carel: Inorganic-scintillator development. Nucl. Instrum. Meth. A 460, 1 (2001).CrossRefGoogle Scholar
2Kleimann, P., Linnros, J., Frojdh, C. and Petersson, C.S.: An x-ray imaging pixel detector based on scintillator filled pores in a silicon matrix. Nucl. Instrum. Meth. A 460, 15 (2001).CrossRefGoogle Scholar
3Zych, E. and Brecher, C.: Temperature dependence of Ce-emission kinetics in YAG:Ce optical ceramic. J. Alloys Compd. 300-301, 495 (2000).CrossRefGoogle Scholar
4Zorenko, Yu., Gorbenko, V., Konstankevych, I., Grinev, B. and Globus, M.: Scintillation properties of Lu3Al5O12:Ce single-crystalline films. Nucl. Instrum. Meth. A 486, 309 (2002).Google Scholar
5Ohno, K. and Abe, T.: Bright green phosphor, Y3Al5−xGaxO12:Tb, for projection CRT. J. Electrochem. Soc. 134, 2072 (1987).CrossRefGoogle Scholar
6van der Weg, W.F. and van Tol, M.W.: Saturation effects of cathodoluminescence in rare-earth activated epitaxial Y3Al5O12 layers. Appl. Phys. Lett. 38, 705 (1981).CrossRefGoogle Scholar
7Ruan, S-K., Zhou, J-G., Zhong, A-M., Duan, J-F., Yang, X-B. and Su, M-Z.: Synthesis of Y3Al5O12:Eu3+ phosphor by sol-gel method and its luminescence behavior. J. Alloys Compd. 275–277, 72 (1998).Google Scholar
8Mishra, D., Anand, S., Panda, R.K. and Das, R.P.: Preparation of barium hexa-aluminate through a hydrothermal precipitation-calcination route and characterization of intermediate and final products. Mater. Lett. 56, 873 (2002).Google Scholar
9Ekambaram, S. and Patil, K.C.: Combustion synthesis of yttria. J. Mater. Chem. 5, 905 (1995).CrossRefGoogle Scholar
10Shea, E.L., McKittrick, J. and Lopez, O.A.: Synthesis of red-emitting, small particle size luminescent oxides using an optimized combustion process. J. Am. Ceram. Soc. 79, 3257 (1996).Google Scholar
11Kakade, M.B., Ramanathan, S. and Roy, S.K.: Synthesis of YAG powder by aluminum nitrate-yttrium nitrate-glycine reaction. J. Mater. Sci. Lett. 21, 927 (2002).Google Scholar
12Zych, E., Hreniak, D., Strek, W., Kepinski, L. and Domagala, K.: Sintering properties of urea-derived Lu2O3-based phosphors. J. Alloys Compd. 341, 391 (2002).CrossRefGoogle Scholar
13Qi, X., Zhou, J., Yue, Z., Gui, Z. and Li, L.: Auto-combustion synthesis of naocrystalline LaFeO3. Mater. Chem. Phys. 78, 25 (2002).Google Scholar
14Pederson, L.R., Maupin, G.D., Weber, W.J., McCready, D.J. and Stephens, R.W.: Combustion synthesis of YBa2Cu3O7: Glycine/metal nitrate method. Mater. Lett. 10, 437 (1991).CrossRefGoogle Scholar
15Hong, C.S., Ravindranathan, P., Agrawal, D.K. and Roy, R.: Synthesis and sintering of Ca0.5Sr0.5Zr4P6O24 powders by the decomposition/combustion of Ca-, Sr-, nitrate-ammonium dihydrogen phosphate-urea mixtures. J. Mater. Res. 9, 2398 (1994).Google Scholar
16Venkatachari, K.R., Huang, D., Ostrander, S.P., Schulze, W.A. and Stangle, G.C.: A combustion synthesis process for synthesizing nanocrystalline zirconia powders. J. Mater. Res. 10, 748 (1995).CrossRefGoogle Scholar
17Kakade, M.B., Ramanathan, S. and Ravindran, P.V.: Yttrium aluminum garnet powders by nitrate decomposition and nitrate-urea solution combustion reactions-a comparative study. J. Alloys Compd. 350, 123 (2003).Google Scholar
18Hwang, C-C., Wu, T-Y., Wan, J. and Tsai, J-S.: Development of a novel combustion synthesis method for synthesizing of ceramic oxide powders. Mater. Sci. Eng. B 111, 49 (2004).CrossRefGoogle Scholar
19Boschini, F., Robertz, B., Rulmont, A. and Cloots, R.: Preparation of nanosized barium zirconate powder by thermal decomposition of urea in an aqueous solution containing barium and zirconium, and by calcinations of the precipitate. J. Eur. Ceram. Soc. 23, 3035 (2003).CrossRefGoogle Scholar
20Berdowski, P.A.M., Lammers, M.J.J. and Blasse, G.: 5D3-5D4 cross relaxation in Tb3+ pairs in CsCdBr3 crystals. J. Chem. Phys. 83, 475 (1985).Google Scholar
21Fruehan, R.J. and Richardson, F.D.: Activities of oxygen in liquid copper and its alloys with silver and tin. Trans. Metall. Soc. AIME 245, 1721 (1969).Google Scholar
22Blasse, G.: Luminescence of inorganic solids: trends and applications. Rev. Inorg. Chem. 5, 319 (1983).Google Scholar