Hostname: page-component-cd9895bd7-lnqnp Total loading time: 0 Render date: 2024-12-24T16:55:10.328Z Has data issue: false hasContentIssue false
  • English
  • Français

Chemomechanical effects of long-chain alcohols during nanoindentation

Published online by Cambridge University Press:  19 September 2011

Bedabibhas Mohanty  and
Adrian B. Mann
Bedabibhas Mohanty*
Affiliation:
Department of Materials Science and Engineering, Rutgers The State University of New Jersey, Piscataway, New Jersey 08854; and Institute for Advanced Materials, Devices and Nanotechnology, Rutgers The State University of New Jersey, Piscataway, New Jersey 08854
Adrian B. Mann
Affiliation:
Department of Materials Science and Engineering, Rutgers The State University of New Jersey, Piscataway, New Jersey 08854; and Institute for Advanced Materials, Devices and Nanotechnology, Rutgers The State University of New Jersey, Piscataway, New Jersey 08854
*
a)Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

Surface and chemomechanical effects are very important in tribology, wear and friction, but are difficult to quantify due to being confined in the near-surface region. Nanoindentation techniques have been successfully used to investigate environmental effects on mechanical response. In this work, nanoindentation tests have been performed on various materials (silicon, fused silica, and gold nanofilms on a glass substrate) immersed in long-chain alcohols (i.e., 1-hexanol, 1-heptanol, 1-octanol, and 1-nonanol). The results consistently show an increase in mechanical properties for silicon and gold nanofilms immersed in the alcohols at shallow nanoindentation depths. The results for fused silica show little effect of immersion. The changes in the observed mechanical properties are attributed to the ability of the long-chain organic molecules to sustain elastic strains when they are in confined geometry. These long organic chains also distribute the normal stress of the indenter over a larger area on the sample surface thereby causing a decrease in the perceived contact area (Ac). As a result the long-chain alcohols modify both the Ac and the elastic compliance of the contact.

Keywords

NanoindentationTribology
Type
Articles
Information
Journal of Materials Research , Volume 27 , Issue 1: Focus Issue: Instrumented Indentation , 14 January 2012 , pp. 222 - 228
Copyright
Copyright © Materials Research Society 2011

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Rehbinder, P.: New physico-chemical phenomena in the deformation and mechanical treatment of solids. Nature 159, 866 (1947).CrossRefGoogle Scholar
2.Fisher, T.E., Anderson, M.P., Jahanmir, S., and Shlhei, R.: Friction and wear of tough and brittle zirconia in nitrogen, air, water, hexadecane and hexadecane containing stearic acid. Wear 124, 133 (1988).CrossRefGoogle Scholar
3.Sasaki, S.: Effects of surrounding atmosphere on friction and wear of alumina, zirconia, silicon carbide and silicon nitride. Wear 134, 185 (1989).CrossRefGoogle Scholar
4.Fischer, T.E.: Tribochemistry. Annu. Rev. Mater. Sci. 18, 303 (1988).CrossRefGoogle Scholar
5.Kim, D.S., Fischer, T.E., and Gallois, B.: The effects of oxygen and humidity on friction and wear of diamond-like carbon-films. Surf. Coat. Tech. 49, 537 (1991).CrossRefGoogle Scholar
6.Singer, I.L., Fayeulle, S., and Ehni, P.D.: Friction and wear behavior of Tin in air—The chemistry of transfer films and debris formation. Wear 149, 375 (1991).CrossRefGoogle Scholar
7.Westwood, A.R.C., Macmillan, N.H., and Lalyoncu, R.S.: Environment sensitive hardness and machinability of Al2O3. J. Am. Ceram. Soc. 56, 258 (1973).CrossRefGoogle Scholar
8.Macmillan, N.H., Huntting, R.D., and Westwood, A.R.C.: Chemo-mechanical control of sliding friction behavior in non-metals. J. Mater. Sci. 9, 697 (1974).CrossRefGoogle Scholar
9.Czernuszka, J.T. and Page, T.F.: Characterizing the surface contact behavior of ceramics, Part 2-Chemo-mechanical effects. J. Mater. Sci. 22, 3917 (1987).CrossRefGoogle Scholar
10.Hainsworth, S.V. and Page, T.F.: Nanoindentation studies of the chemo-mechanical effect in sapphire. J. Mater. Sci. 29, 5529 (1994).CrossRefGoogle Scholar
11.Hainsworth, S.V. and Page, T.F.: Nanoindentation studies of chemomechanical effects in thin film coated systems. Surf. Coat. Tech. 68, 571 (1994).CrossRefGoogle Scholar
12.Sasaki, S. and Pethica, J.B.: Effects of surrounding atmosphere on micro-hardness and tribological properties of sintered alumina. Wear 241, 204 (2000).CrossRefGoogle Scholar
13.Gerberich, W.W., Venkataraman, S.K., Huang, H., Harvey, S.E., and Kohlstedt, D.L.: The injection of plasticity by millinewton contacts. Acta Metall. Mater. 43, 1569 (1995).CrossRefGoogle Scholar
14.Venkataraman, S.K., Kohlstedt, D.L., and Gerberich, W.W.: Continuous microindentation of passivating surfaces. J. Mater. Res. 8, 685 (1993).CrossRefGoogle Scholar
15.Mann, A.B. and Pethica, J.B.: Nanoindentation studies in a liquid environment. Langmuir 12, 4583 (1996).CrossRefGoogle Scholar
16.Mann, A.B.: Mechanics and geometry of nanoasperity contacts in organic fluids. Appl. Phys. Lett. 85, 5203 (2004).CrossRefGoogle Scholar
17.Bembey, A.K., Bushby, A.J., Boyde, A., Ferguson, V.L., and Oyen, M.L.: Hydration effects on the micro-mechanical properties of bone. J. Mater. Res. 21, 1962 (2006).CrossRefGoogle Scholar
18.Guidoni, G., Swain, M., and Jager, J.: Nanoindentation of wet and dry compact bone: Influence of environment and indenter tip geometry on the indentation modulus. Philos. Mag. 90, 553 (2010).CrossRefGoogle Scholar
19.Ebenstein, D.M. and Pruitt, L.A.: Nanoindentation of soft hydrated materials for application to vascular tissues. J. Biomed. Mater. Res. Part A 69A, 222 (2004).CrossRefGoogle Scholar
20.Hengsberger, S., Kulik, A., and Zysset, P.H.: Nanoindentation discriminates the elastic properties of individual human bone lamellae under dry and physiological conditions. Bone 30, 178 (2002).CrossRefGoogle ScholarPubMed
21.Barnoush, A. and Vehoff, H.: In situ electrochemical nanoindentation: A technique for local examination of hydrogen embrittlement. Corros. Sci. 50, 259 (2008).CrossRefGoogle Scholar
22.Barnoush, A., Bies, C., and Vehoff, H.: In situ electrochemical nanoindentation of FeAl (100) single crystal: Hydrogen effect on dislocation nucleation. J. Mater. Res. 24, 1105 (2009).CrossRefGoogle Scholar
23.Oliver, W.C. and Pharr, G.M.: An improved technique for determining hardness and elastic-modulus using load and displacement sensing indentation experiments. J. Mater. Res. 7, 1564 (1992).CrossRefGoogle Scholar