Hostname: page-component-586b7cd67f-rcrh6 Total loading time: 0 Render date: 2024-11-29T07:56:10.785Z Has data issue: false hasContentIssue false
  • English
  • Français

Influence of Water and Other Contaminants in Electrolyte Solutions on Lithium Electrodeposition

Published online by Cambridge University Press:  10 February 2011

T. Fujieda ,
S. Koike  and
S. Higuchi
T. Fujieda
Affiliation:
Osaka National Research Institute Ikeda, Osaka, Japan
S. Koike
Affiliation:
Osaka National Research Institute Ikeda, Osaka, Japan
S. Higuchi
Affiliation:
Osaka National Research Institute Ikeda, Osaka, Japan
Get access

Abstract

Electrochemistry of a nickel electrode in propylene carbonate [PC] containing LiClO4, LiCF3SO3, LiPF6 was studied through a micro electrode (φ =25 μ m) techniques in the wide potential range between +4.5 and -0.2 V vs. Li/Li+. Common pronounced peaks were observed in the potential range positive to lithium electrodeposition on nickel in all electrolyte solutions examined. Thus, these peaks can be attributed to reactions related to Li+ or commonly contained contaminants such as water and acids. In particular, the peak which appeared at the most negative potential seemed to be underpotential deposition (UPD) of lithium.

To prove this hypothesis a nickel electrode in highly dried PC (water content : 3 – 8 ppm) intentionally contaminated with a small amount of water and CF3COOH was examined via cyclic voltammetry. Changing the content of water and acid (and its ratio) in PC resulted in a variety of voltammograms and one of them was identical to the one observed in PC containing lithium electrolytes. These facts preclude the existence of UPD of lithium on nickel in the electrolyte solutions. Instead, the existence of NiOH on nickel and its redox reaction mechanism have been postulated. The mechanism is consistent with the experimental facts : a nickel electrode passivates in PC with a small amount of water, and a small amount of acid, CF3COOH, can prevent passivation. The vicinity of the electrode surface may be exposed to an alkaline atmosphere owing to the reduction product of water. This seems to be the cause of troubles we run into with the electrodes at cathodic potentials

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 496: Symposium Y – Materials For Electrochemical Energy Storage & Conversion II… , 1997 , 463
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Aurbach, D. and Zaban, A., J. Electroana. Chem., 348, p. 155 (1993).Google Scholar
2. Pletcher, D., Rohan, J. F. and Ritchie, A. G., Electrochimica Acta, 39, p. 1369 (1994).10.1016/0013-4686(94)E0069-CGoogle Scholar
3. Wagner, D. and Genscher, H., Electrochimica Acta, 34, p. 297 (1994).Google Scholar
4. Aurbach, D., Daroux, M., Faguy, P., and Yeager, E., J. Electroana. Chem., 297, p. 225 (1991).Google Scholar
5. Arvia, A. J. and Posadas, D. in Encyclopedia of Electrochemistry of the elements vol. 3 edited by Bard, A. J., Marcel Dekker, Inc., New york and Basel, 1973, p. 212.Google Scholar