This paper presents the results of relativistic calculation intended specifically to investigate the dominant states for dielectronic recombination of Li-like into Be-like Al ions in short-pulse laser produced plasmas. The relativistic Dirac R-matrix calculation is performed to output resonance energy levels and rates. The target energies and orbitals are calculated with the extended average level multi-configurational Dirac-Fock method in the general-purpose relativistic atomic structure package. This type of calculation gives a set of 13 bound orbitals that is optimized over all the levels included. The resulting 13 relativistic orbitals produced 74 Jπ levels, all of which are to be used in the close-coupling expansion. To the best of our knowledge, the work reported herein describes for the first time such detailed calculation for this atomic system and the results are relevant to the short-pulse laser produced plasma modeling.

This paper deals with the analysis of growth rate of modulation instability of a laser pulse propagating in a clustered gas. Finite pulse effects are considered to be a perturbation. Growth rates of modulation instability for 100 fs and 80 fs at the centroid as well as at the front and back of the pulses are evaluated and graphically analyzed. It has been shown that with decrease in pulse duration the growth rate of modulation instability increases at the front, back as well as at the centroid of the pulse. It is also shown that the change in growth rate of modulation instability at the front as well as at the back of the pulse in comparison to the centroid of the pulse for 80 fs pulse is less in comparison to that of 100 fs pulse.

Analytical far-field expressions for the transverse electric mode and transverse electric magnetic mode terms, and the energy flux distributions of vortex Airy beams are derived based on the vector angular spectrum of the beam and the stationary phase method. The physical pictures of vortex Airy beams from the vectorial structure are illustrated and the energy flux distributions are demonstrated in far-field. The influences of the beam parameters, especially the exponential factor, on the energy flux distributions of vortex Airy beams and its transverse electric mode and transverse electric magnetic mode terms are discussed. This work provides a new understanding of the propagation behaviors and applications of a vortex Airy beam.

In this paper the classical theory of Above Threshold Ionization (ATI) in the oxygen plasma was used to show how the residual electron energy depends on the laser parameters such as pulse length, wavelength and peak intensity. The value of ATI energy is found to increase with laser wavelength and its intensity. Our study conducted for three cases of τ > 2π/νp, τ = 2π/ωp, and τ < 2π/ωp, where ωp is the plasma frequency, reveals that the ATI energy is decreased for the pulse duration τ ≠ 2π/ωp. Also it is showed how the space charge effect can reduce the residual electron energy to a minimum value, in a suitable condition. By optimizing various parameters, we can generate the cold electrons suitable for the recombination x-ray laser.

We present a three-dimensional code for the optimization of energy storage, heat deposition, and amplification in square-shaped laser slabs and multi-slab laser amplifiers. The influence of the slab dimensions, slab face and edge reflectivities, pump parameters, and operating temperature on amplified spontaneous emission and stored energy has been investigated. The multi-slab and single-slab configurations are compared, analyzing in detail the influence of the absorption cladding for the suppression of amplified spontaneous emission radiation.

In fast ignition, optimization of laser profile for core heating is one approach to ignite the core. However, the profile is not so optimized and its effects on fast electron characteristics are not fully clarified yet. The laser profile is optimized under the condition of same laser energy because laser energy is restricted in experiments. Therefore, we investigate effects of laser profile on fast electron generation under the condition of same laser energy. In this paper, each effect of laser temporal and spatial profile is estimated independently using two-dimensional Particle-In-Cell simulations. We conclude that lower intensity laser suitable for fast ignition under the limit of simulated parameters when energy of laser is same because efficient core-heating electrons are much generated and divergence angle is smaller in low-intensity case compared to high-intensity case.

This paper reports on the creation of a THL-100 multi-terawatt hybrid laser system based on a Start-480M titanium-sapphire starting complex and photochemical XeF(C-A) amplifier with a 25-cm aperture. The complex produces 50-fs radiation pulses of energy up to 5 mJ at a second harmonic wavelength of 475 nm. The active medium of the amplifier is created in a XeF2/N2 mixture under vacuum-ultraviolet radiation of electron beam-excited xenon. The results of first experiments on femtosecond pulse amplification in the active medium of the XeF(C-A) amplifier are presented to demonstrate that a laser beam peak power of 14 TW has been attained.

In this paper, we extend our previous work of classical over barrier ionization (COBI) model to study the multiple-ionization and mean charge state of noble gases colliding with heavy ions at energies close to the Bragg peak region ranging up to some hundreds of keV/amu. The method we report is in good agreement with experimental data and offers the advantage of very small computation time. Therefore, this model will be extremely helpful to be included in numerical codes to calculate the charge state distribution in plasma.

Hemispherical electron plasma waves generated from ultraintense laser interacting with a solid target having a subcritical preplasma is studied using particle-in-cell simulation. As the laser pulse propagates inside the preplasma, it becomes self-focused due to the response of the plasma electrons to the ponderomotive force. The electrons are mainly heated via betatron resonance absorption and their thermal energy can become higher than the ponderomotive energy. The hot electrons easily penetrate through the thin solid target and appear behind it as periodic hemispherical shell-like layers separated by the laser wavelength.

In this work, a laser-produced plasma extreme ultraviolet source and a free electron laser were used to create Ne photo-ionized plasmas. In both cases, a radiation beam was focused onto a gas stream injected into a vacuum chamber synchronously with the radiation pulse. Extreme ultraviolet radiation from the plasma spanned a wide spectral range with pronounced maximum centered at λ = 11 ± 1 nm while the free electron laser pulses were emitted at a wavelength of 32 nm. The power density of the focused plasma radiation was approximately 2 × 107 W/cm2 and was seven orders of magnitude lower compared with the focused free electron laser beam. Radiation fluences in both experimental conditions were comparable. Despite quite different spectral characteristics and extremely different power densities, emission spectra of both photo-ionized plasmas consist of the same spectral lines within a wavelength range of 20 to 50 nm, however, with different relative intensities of the corresponding lines. The dominating spectral lines originated from singly charged ions (Ne II); however, Ne III lines were also detected. Additionally, computer simulations of the emission spectra, obtained for photo-ionized plasmas, driven by the plasma extreme ultraviolet source, were performed. The corresponding measured and calculated spectra are presented. An electron temperature and ionic composition were estimated. Differences between the experimental spectra, obtained for both irradiation conditions, were analyzed. The differences were attributed mainly to different energies of driving photons.

The high power microwave (HPM) synthesis method is presented in this paper for gigawatt level. The gigawatt level HPM could be synthesized from two separate input wave-guides according to the coupled-wave and orthogonal polarization theory. The synthesizer is used by two back to back circular wave-guides. The main channel is the circular wave-guide connected to the output port, which transmits horizontal polarization TE011 mode. The operating bandwidth is only limited by the barrier wave-length λc of circular wave-guide. The sub-channel transmits vertical polarization TE011 mode and the operating bandwidth is up to several hundred MHz. The energy of sub-channel could be coupled into main channel through continuous long-slit coupling structure. The synthesizer can be analyzed using numerical simulation method, which focuses on the power capability. The simulation results indicate that the transmission efficiency of the main channel is above 99%, the coupling efficiency of the sub-channel is above 96%, which also validates the reasonability of synthesizer design. At the same time, the prototype of synthesizer is designed and the HPM experiment system is established. The transmitting and coupling efficiency are both greater than 95% in cold test condition and they are also greater than 90% in gigawatt class test condition, the power capability of the synthesizer reaches about 1.2GW. The test results validate the feasibility of synthesizer for gigawatt class HPM.

A new concept of generating tight bunches of electrons accelerated to high energies is proposed. The electrons are born via ionization of a low-density neutral gas by laser radiation, and the concept is based on the electrons acceleration in traps arising within the pattern of interference of several relativistically intense laser pulses with amplitude fronts tilted relative to their phase fronts. The traps move with the speed of light and (1) collect electrons; (2) compress them to extremely high density in all dimensions, forming electron bunches; and (3) accelerate the resulting bunches to energies of at least several GeV per electron. The simulations of bunch formation employ the Newton equation with the corresponding Lorentz force.

This paper presents a model for excitation of electron plasma wave and resulting stimulated Raman scattering due to presence of a laser beam carrying null intensity in center (hollow Gaussian beam) in a collisionless plasma. We have studied the self-focusing of the hollow Gaussian beam and its effect on back stimulated Raman scattering process in the presence of ponderomotive nonlinearity. To understand the nature of propagation of the hollow Gaussian beam, electron plasma wave and back reflectivity, a paraxial-ray approximation has been invoked. It is predicted that self-focusing and back reflectivity reduces for higher order of hollow Gaussian beam.

In this paper, we discuss the competition between the stimulated Raman scattering (SRS) and stimulated Brillouin scattering (SBS) instabilities under the strong damping condition. Based on a five-wave interaction model, relations of the stationary backscattering reflectivity between SRS and SBS are deduced in the case of homogeneous plasmas. Developments of the two coexistent instabilities are simulated with different parameters. The density and the temperature of plasma are found to be important in determining which instability dominates the backscattering in the regime of competition. Furthermore, the influence of inhomogeneous condition to the pattern of competition is analyzed. Numerical results consist with our theoretical results.

A massive deuterated polyethylene target was exposed to laser intensities of about 3 × 1016 W/cm2 employing the 3-TW Prague Asterix Laser System (PALS). We achieved a yield of 2 × 108 neutrons per laser shot. Average time-of-flight signals of scintillation detectors operated in current mode reveal broad energy spectra of fusion neutrons with dominating energy of about 2.45 MeV. The energy dependence of the neutron yield shows a consistency in results of nanosecond, picosecond and sub-picosecond experiments. Here we also show that ions emitted in the backward direction from the front target surface have a multi-peak energy spectrum, which is caused by burst emission mechanisms.

In fast ignition of inertial confinement fusion, hot electron beam is considered to be an appropriate energy source for ignition. However, hot electrons are divergent as they are transporting in over-dense plasma. So collimating the hot electrons becomes one of the most important issues in fast ignition. A method to collimate hot electron beam by external magnetic field is proposed in this paper. The external field can be generated by compressing a seed magnetic field at the stage of laser-driven implosion. This method is confirmed by particle-in-cell simulations. The results show that hot electrons are well collimated by external magnetic field from magnetic-flux compression.

The response of titanium surface irradiated with high intensity (1013 – 1015 W/cm2) Ti:sapphire laser was studied in vacuum. Most of the reported investigations were conducted with nano- to femtosecond lasers in gas atmospheres while the studies of titanium surface interacting with femtosecond laser in vacuum are scarce. The laser employed in our experiment was operating at 800 nm wavelength and pulse duration of 60 fs in single pulse regime. The observed surface changes and phenomena are (1) creation of craters, (2) formation of periodic surface structures at the reduced intensity, and (3) occurrence of plasma in front the target. Since microstructuring of titanium is very interesting in many areas (industry, medicine), it can be concluded from this study that the reported laser intensities can effectively be applied for micromachining of the titanium surface (increasing the roughness, formation of parallel periodic surface structures etc.).

A design for generation of two ultra-high power laser beams, 130 TW and 1.4 PW, using a chain of optical parametric chirped pulse amplifiers, first pumped by a 10 Hz frequency doubled Nd:YAG laser, and later by the frequency tripled single-shot kilojoule level iodine laser Prague Asterix Laser System is presented. Expected enhancement of the parameters in the upgrade, besides the output power, are up to 1022 W/cm2 from 1016 W/cm2 in target intensity, and about 20 fs from 0.5 ns in pulse duration. Owing to the limited dimensions of the Prague Asterix Laser System building, the lay-out of the new equipment had to use only the left-over space in the laser hall.