Fluorescent x-ray energy spectra were successfully acquired from uranium and plutonium in 400:1 ratios in samples containing 2 Ci/gram of mixed fission products. The analytical system consists of a silver transmission anode x-ray tube, a low-Z scattering chamber, a magnetic ß-ray trap, a beam monitor probe, a commercial Si(Li) detector, a set of modified electronics to handle the large γ-ray overload rate, and a Computer analyzer using a higher-level language to handle data reduction.

The Computer programs used to obtain peak areas from the closely spaced uranium and plutonium (Lα 1+2) peaks were constructed to make use of knowledge of upper-edge tailing gained in this experiment. Programs are being developed to properly remove background under the uranium and plutonium peaks. Absorption effects in the larger samples have been measured using the ratio of uranium (Lℓ) to uranium (Lα) peak area and are incorporated in the data-analysis schemes. A titanium monitor probe, consisting of a fixed titanium plate near the sample, introduces a constant-area titanium K x-ray line into the spectrum. The program uses the area of this peak to correct for effects of total exciting flux, geometry, and system dead-time losses. Standard samples of various types are used to generate calibration curves from which quantitative results are obtained.

Samples are taken from dissolved high-burnup power-reactor fuel rods. The liquid sample is acidic and has a radiation level at one foot of approximately 2 R/hr ß and 300 mR/hr γ. Sample preparation involves only the evaporation of the liquid sample on a 1/2-mil polycarbonate substrate and subsequent sealing with another layer of polycarbonate film. The samples are then mounted in standard 35-mm slide-holders.

Preliminary testing on a limited number of prepared uranium and plutonium samples indicates a precision of about 1% and an accuracy of about 2%, over a range of 1 to 58 μg total mass. The samples have not yet been verified by independent chemical analysis. The system has been installed at the AEC Savannah River facility for extensive testing.